Home
Главная
Stingray
Утюг
ST-IR200A
Инструкция по эксплуатации Страница: 7

Stingray ST-IR200A Инструкция по эксплуатации онлайн [7/11] 904838

• Avoid of ironing zippers, rivets, etc., as they can scratch soleplate.

• Do not place steam iron on the metal or rough surface.

• Move steam iron carefully to avoid burns, because of there could be hot water leakage, as well as hot steam.

USING THE APPLIANCE

SETTING TEMPERATURE

• Sort the fabric: wool with wool, cotton with cotton, etc. Start ironing the fabrics requiring the lowest temperature and progress to the higher ones, because the steam iron heats up quicker than it cools

down.

• If the fabric consists of various kinds of fibers, start ironing the fabrics requiring the lowest temperature (e.g. article consisting of 60% polyester and 40% cotton should be ironed at the temperature

indicated for polyester (•) and without steam.

• Turn the temperature control dial round until it is opposite the setting pointer.

LABEL

TYPE OF TEXTILE

Do not iron this article

•

Synthetics

••

Silk, Wool

•••

Cotton, Linen

ANTI-CALC SYSTEM

A special filter inside the water reservoir softens the water and prevents scale build-up in the plate. The filter is permanent and does not need replacing.

NOTE: Use tap water only. Distilled water makes the anti-calc system ineffective by altering its physicochemical characteristics.

Do not use chemical additives, scented substances or decalcifiers.

ANTI-DRIP SYSTEM

This iron is equipped with drip stop function: the iron automatically stops steaming when the temperature is too low to prevent water from dripping out of the soleplate. With the anti-dripping system, you can

perfectly iron even the most delicate fabrics.

FILLING THE WATER TANK

• Unplug the steam iron before filling.

• Make sure that both the Steam Control turning Knob and Temperature Control Dial are in “OFF” position.

• Hold the steam iron in the horizontal position.

• Slowly pour water into the water fill opening with the help of plastic beaker.

• Do not fill higher than indication “МАX” of the water tank, in order to avoid spilling out of water.

• If you have to refill while ironing, unplug the appliance from the power supply before filling.

EMPTYING THE WATER TANK

The water tank should be emptied after each use.

• Unplug the steam iron from the power supply.

• While the steam iron is still warm, hold the steam iron over a sink and allow the steam iron to drain by tipping the point of the steam iron down

• Gently shake the steam iron to loosen any water drops that may be trapped. The warmth of the iron should dry out any remaining water.

Stingray ST-IR200A Инструкция по эксплуатации онлайн [7/11] 904838

Похожие устройства