Планар 2Д-12 Инструкция по эксплуатации онлайн [35/54] 219145

PLANAR-2D-12/24 ENG

6.2 The control panel «ПУ-16М» is intended for:

- heater activation and deactivation in manual mode;

- choice of a way of management «on power» or «on temperature»;

- activation of "waiting" mode

- indication of the established temperature or power;

- indications of temperature of one of 3х sensors (built in the heater, built in the control

panel or remote – cabin temperature sensor, if it is connected);

-failure code indication in case of heater failure while operation.

6.2.1 The front board of the panel contains: four-digit light emitting diode (LED)

indicator, three LEDs and three knobs. Functionality of the knobs and LEDs. (fig.6.2)

Fig. 6.2- Control panel «ПУ-16М»

The way of management "on power" is intended for the fastest heating of the room. If

to establish "max" power, the heater will constantly work with the maximum heating

capacity. In operating time of a heater it is possible to set it's power (8 steps of power).

The way of management "on temperature" is intended for maintenance in necessary

temperature. If the measured temperature is less established, the heater will work at "max"

power. When indoors temperature will come nearer to the established value, heating

capacity of a heater will start decreasing. And, the less difference of temperatures, the is

less heater heating capacity.

Waiting mode is a mode on which process of burning stops and air ventilation

indoors begins. Ventilation is necessary for maintenance of identical temperature in all

room. During ventilation temperature in the room is constantly measured and if it

becomes lower than established, the heater will be started again.