Brother QL-560 [12/19] Your ql 500 560 comes with a paper guide that collects strips of printed labels that have not been cut off from the machine

Getting started

Your QL-500/560 comes with a

paper guide that collects strips of

printed labels that have not been

cut off from the machine.

Attach the paper guide to the front of

the QL-500/560 as shown in the figure.

Remove the paper guide when printing

more than 10 labels continuously and

cutting each label automatically

(QL-560 only).

Connect the AC power cord to the QL-500/560 and

then plug the power supply cord into a standard

electrical socket.

• Check that the electrical socket is 220 ~ 240 V before inserting

the plug.

• Remove the power supply cord from the electrical socket after

you have finished using the QL-500/560.

• Do not pull the cord when removing it from the electrical

socket. The wire in the cord may become damaged.

Lift the label lever and then thread the

end of the DK Roll into the slot

immediately before the cutter.

When unable to thread the end of the DK

Roll into the slot, thread it as far as

possible, then lower the label lever and

close the cover. Press the ON/OFF button

to turn the QL-500/560 on, and then press

the FEED button to set the roll.

Lower the label lever and then close the DK

Roll compartment cover.

3 Installing the paper guide

Paper guide

Connecting to the power supply