Sven MS-2020 [23/28] Radio mode

ENG

MS-2020

Operation Manual

• In order to have the high-delity reception orient the antenna in direction of radio signal when

listening to the radio, rst connecting the antenna to ANTENNA jack g.

• When the MSS operation is over, mind to switch it o using switch k (OFF position) and unplug

the power cord j from the socket.

6. OPERATION MODES

Player Mode

• The system will enter the Player mode automatically when a carrier (USB ﬂash or SD card)

is connected to corresponding ports l or m, or press SOURCE button b on the front panel

ofthe subwoofer or SOURCE button b on the remote control.

• To select a track, you can directly enter its number on the remote control using the numeric

pad buttons i or select it with the buttons c or f on the front panel. The display a will show

thetrack number for a short time and then the playback time elapsed.

Bluetooth Mode

• In order to transmit signal in this mode it is necessary at rst to connect the device with a signal

source (see Fig. 6). For this purpose select the Bluetooth mode using SOURCE button b on

thefront panel of the subwoofer or SOURCE button b on the remote control. The speaker system

will enter the search mode «bt» mode will be shown on the display a.

• It is necessary to select the search mode of devices with Bluetooth on a signal source (telephone,

notebook, smartphone, etc.). «SVEN MS-2020», message will be displayed on the screen which

it should be connected to*.

• The «bt» lights continuously when connection is successful. If there is no connection, lettering

«bt» will blink. In this case the system should be switched over to the search mode once again (turn

o and turn on Bluetooth mode)**.

Radio Mode

• Use SOURCE button b on the front panel of the subwoofer or SOURCE button b on the remote

control to enter the Radio mode. The display a will backlight the current adjustment frequency.

• Press and hold SCAN button e on the front panel of the subwoofer or button AUTO g

ontheremote control short to auto scan and memorize the found stations. The display a shows

the frequency being scanned, when a radio station is being memorized, the display shows its

assigned sequence number for a short moment.

• For manual scanning, use buttons TUNE -/+ d on the remote control (up/down the frequency

range).

• To store a radio station in memory, short pressing button SAVE l on the remote control, then

select the cell with the buttons f, h and again brieﬂy presses button SAVE l.

• If preset radio stations are available in the memory, you can switch from one to another by short

pressing buttons c and f on the front panel of the subwoofer or buttons f and h ontheremote

control.

* You might have to enter “0000” code to connect some models via Bluetooth.

** If an item has been already registered in the device list of sources, then the second search mode

activation is not needed. Choose only the item name and the “connect” command on the source.