Gigabyte MZ31-AR0 (rev. 2.x) [115/134] 10 2 firmware image location

- 115 - Gigabyte Server Management Console

mkdir /tftpboot

chmod -R 777 /tftpboot

chown -R nobody /tftpboot

5. Toreceivetheleyouhavetotouchtheleandgivepermissiontoaccessbyallusers

>touch<DIR>/conf.bak

>chmod777<DIR>/conf.bak

6. Even after all this step has been done and still facing error of timeout:

a) Checkwith/etc/xinetd.d/tftpleanduncommenttheEOF(Removethe‘#’ 

before the EOF alone).

b) Restart the server.

2-10-2 Firmware Image Location

ThispageisusedtocongurermwareimageintotheBMC.

To open Firmware Image Location, click Maintenance > Firmware Image Location from the

menu bar.

A sample screenshot of Firmware Image Location page is shown below.

The various options of Image Transfer Protocol are given below.

Image Location Type:TypeoflocationtotransferthermwareimageintotheBMCeitherWeb

Upload during Flash or TFTP Server.

TFTP Server Address:Addressoftheserverwherethermwareimageisstored.

Note: The Server supports both IPv4 and IPv6 addresses

IP Address made of 4 numbers separated by dots as in “xxx.xxx.xxx.xxx”.

Each number ranges from 0 to 255.

First number must not be 0.

IPv6 Address made of 8 groups of 4 Hexadecimal digits separated by colon as in

“xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx.”