Home
Главная
Oleo-Mac
Воздуходувка Ранцевая
BV900
Руководство по эксплуатации Страница: 28

Oleo-Mac BV900 Руководство по эксплуатации онлайн [28/200] 768808

its vertical position until it clicks into place

(Fig.11).

· Pull the handle once again to start the engine.

Keep the engine at idle speed for at least one

minute before accelerating to full revs.

Starting with a warm engine

· Press the primer bulb (A, Fig.12) fully down,

slowly, 10 times.

· Raise the choke lever (B, Fig.12) until you hear

a click.

· Check that the switch (2, Fig.13) is in position

“1” (on).

· Place your left hand on the engine cowling

and your left foot on the frame to keep the

machine steady.

· Use your right hand to pull the handle (4,

Fig.1) until you encounter slight resistance.

Without releasing the rope, pull with a short

sharp gesture. Pulling with insucient force at

this point may result in ooding of the engine.

· Keep the engine at idling speed for at least

one minute before accelerating to full revs.

Procedure in the case of a ooded engine

· Remove the spark plug (3, Fig.1) using the

supplied wrench, then clean it and dry it.

· Check that the choke lever B is in its horizontal

position as shown in Fig.11.

· Pull the starter handle (4, Fig.1) at least 20

times.

· Fit the spark plug; bring the xed throttle lever

to the max revs position (4, Fig.13).

· Start the engine.

If the engine fails to start, proceed as follows:

· Remove the spark plug using the supplied

wrench, then clean it and dry it.

· Turn the engine upside down with the spark

plug bore facing downward.

· Pull the starter handle (4, Fig.1) at least 20

times and check whether fuel drips from the

spark plug bore.

· Dry the surfaces around the spark plug bore.

· Ret the spark plug and repeat the operations

with the throttle lever (1, Fig.13) in the max

speed position and the choke lever (B) in its

horizontal position as shown in Fig.11.

inspect the gasket.

5. Immediately replace fuel cap and hand

tighten. Wipe up any fuel spillage.

WARNING: Check for fuel leaks, if any are

found, correct before use. Contact a Servicing

Dealer if necessary.

START-UP PROCEDURE

Blower controls – Control handle (Fig.13)

· To accelerate press throttle trigger (1) together

with safety lever (3).

· To start the engine switch (2) must be set to

“1”.

· If you want to work with the engine at xed

speed, press safety lever (3) and move lever

(4) towards the “+” mark until obtaining the

required engine rpm. To disable the fixed

speed setting, return the lever to the “-”

position.

· To stop the engine, set switch (2) to “0”.

Starting

Before starting the engine:

· Place the machine on an area of at ground.

· Check that the switch (2, Fig.13) is not in

position “0” (o ).

· Make sure that there is no one near the

machine and/or in front of the blower tube.

Starting a cold engine (engine stopped for

more than 30 minutes)

· Press the primer bulb (A, Fig.12) fully down,

slowly, 10 times.

· Lower the choke lever (B, Fig.12) until you

hear a click.