Oleo-Mac BV900 Руководство по эксплуатации онлайн [37/200] 768808

Oleo-Mac BV900 Руководство по эксплуатации онлайн [37/200] 768808
33
GB
15. TROUBLESHOOTING CHART
WARNING: Always stop unit and disconnect spark plug before performing all of the recommended
remedies below except remedies that require operation of the unit.
When you have checked all the possible causes listed and you are still experiencing the problem, see your Servicing
Dealer. If you are experiencing a problem that is not listed in this chart, see your Servicing Dealer for service.
PROBLEM POSSIBLE CAUSE SOLUTION
Engine will not start or will
run only a few seconds after
starting.
(Make sure Ignition switch
is in start position “I”)
1. No spark
2. Flooded engine.
1. Watch for spark at spark plug tip. If
there is no spark, repeat test with a
new spark plug (RCJ6Y).
2. Follow procedure page 24 If engine
still fails to start, repeat procedure
with a new spark plug.
Engine starts but will not
accelerate properly or will not
run properly at high speed.
Carburetor requires
adjustment.
Contact a Servicing Dealer for
carburetor adjustment.
Engine does not reach full
speed and / or emits
excessive smoke
1. Check oil fuel mixture.
2. Air filter dirty.
3. Carburetor requires
adjustment.
1. Use fresh fuel and the correct
2-cycle oil mix.
2. Clean per instruction in
Maintenance-Air Filter Section.
3. Contact a Servicing Dealer for
carburetor adjustment.
Engine starts, runs and
accelerates but will not idle.
Carburetor requires
adjustment.
Contact a Servicing Dealer for
carburetor adjustment.
The engine starts and runs,
but the air flow is low
1. Safety guard blocked
2. Impeller damaged
3. Impeller housing and
tubes blocked
1. Clean safety guard
2. Contact an Authorised Service
Centre
3. Clean

Содержание

Скачать