Miele SGDA3 Complete C3 PowerLine Руководство по эксплуатации онлайн [59/72] 772483
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Miele SGDA3 Complete C3 PowerLine Руководство по эксплуатации онлайн [59/72] 772483

Miele SGDA3 Complete C3 PowerLine Руководство по эксплуатации онлайн [59/72] 772483
en
59
2. If you wish to replace exhaust filter b,
c, d or e with filter a it is essential
that you also fit the filter grille* (dia.
36).
* Filter grille – see “Optional ac-
cessories”
Maintenance indicator with reset but-
ton (dia. 39)
Some models are fitted with a mainten-
ance indicator.
The indicator lights up after approx. 50
hours of operation, which is equivalent
to about a year of average use. The
level of soiling of the dust compartment
filter and the exhaust filter must be
checked at this point.
If the filters are replaced, the indicator
must be reset. To do this the vacuum
cleaner must be switched on.
Press the reset button.
The maintenance indicator will go out
and reset to zero.
The indicator can only be reset by
pressing the reset button after the
light has come on. Pressing the but-
ton at any other time will have no ef-
fect.
When to change the battery in the ra-
dio-control handle
Approximately every 18 months.
One 3 V battery (CR 2032) is required.
The vacuum cleaner can still be used
when the battery has run out or if
there is no battery fitted.
To do so, switch the vacuum cleaner
on using the On/Off foot control .
The Standby indicator on the va-
cuum cleaner will light up yellow.
Press the restart button on the va-
cuum cleaner.
The vacuum cleaner can continue to be
used in this way, but only at maximum
power.
How to change the battery in the ra-
dio-control handle (dia. 41)
Undo the screw on the battery com-
partment cover using a cross-tip
screwdriver and then remove the
cover.
Replace the battery with a new one,
making sure the polarity is correct.
Replace the cover and tighten the
screw back up again.
Dispose of the old battery in a muni-
cipal recycling facility.
When to change the thread lifters
(not possible on EcoTeQ Plus floor-
heads)
The thread lifters on the suction inlet to
the floorhead can be replaced. Check
them from time to time and replace
them if the pile has worn down.
How to replace the thread lifters
(dia. 42)
Use a suitable screwdriver to remove
the thread lifters from the slots.
Fit new thread lifters.

Содержание

Похожие устройства

Скачать