Rode NTK Руководство по эксплуатации онлайн [9/12] 776735

- 9 -

• We strongly recommend the use of a pop shield or

ﬁ lter for all vocal recording. These aid in minimising

plosive sounds (hard ‘P’, ‘B’, ‘T’ and ‘K’ sounds)

that produce a sudden jet of air which can cause

the capsule to overload and produce a ‘popping’

sound.

• Any moisture on the microphone capsule can

cause problems for condenser microphones,

however the use of a pop shield or wind shield

(optional accessory WS2) will reduce the risk of this

occurring.

• Placement of the microphone and pop shield

relative to the vocalist may be varied on several

factors including room acoustics, the vocal

performance, and whether the vocalist has a high

or deep voice.

• An ideal reference is to begin with the pop shield

directly in front of the vocalist, and approximately

15cm (6”) away from the microphone. This will assist

in keeping the performer at a constant minimum

distance from the microphone and helps to

maintain reasonable recording levels.

• Experimentation should be made with the angle

from which the microphone is addressed, as

different results can be achieved when the vocalist

is ‘off-axis’ to the microphone (and the gold dot).

• If an earth loop is present (a mains frequency hum)

there is a ground lift switch on the rear panel of

the power supply, which should be raised to the

‘lift’ position. This earth loop can appear when two

devices which are both earthed are connected

together.