70mai Air Compressor Lite (Midrive TP03) Руководство по эксплуатации онлайн [15/32] 785196

5. Pumping

After connecting the gas tube and while the device is

turned on, press the Start button to start pumping. If

the pressure of the gas valve increases rapidly within

a short interval (80 psi in 3 seconds), it means that the

air way is obstructed. Please immediately turn off the

power, detach the rotary nozzle from the tire nozzle

and reconnect the gas tube.

When the air pressure reaches the preset tyre

pressure, the pump will stop working. The pumping

operation is completed.

Remove the car charger connector and the device will

automatically turn off.

4. Presetting the tyre pressure

Follow these steps to preset the tyre pressure:

After the device is turned on, press the R button to

switch the unit of measurement between bar, psi or

kPa.

Press the "+" or "-" button until the numbers start to

flash. Press the "+" or "-" button again to adjust to

the desired value. When the numbers stop flashing,

presetting of the tyre pressure is completed.

6. Packing the device

After using the device, put the power cable and gas tube

in the wire box at the back of the device.

Coil the gas tube around the winding column once, after

reaching the start point, repeat the coiling one more

time, then pack it in the bottom wire box along the gas

tube groove. Close the wire box cover.