AENO EG1 (AEG0001) Руководство по эксплуатации онлайн [8/122] 791156

8 aeno.com/documents

grill on a flat and stable heat-resistant surface in a well-ventilated area. If the

grill contains too many food products at once, so it can hardly be closed, never

use force to close it as you may damage the device. To avoid fire hazard, never

leave the switched-on device unattended. The grill’s cover panel ❷ must be

closed before connecting it to the mains. After cooking, the cooked food shall

be removed from the grill using wooden or heat-resistant spatula only. Do not

use a sharp fork or knife to remove food products from the grill as this may

damage its non-stick coating.

Initial Setup

Unpack the grill and reel out its cable, but do not plug it into the mains socket.

Make sure that the drip tray ❽ is installed on the plate ❾ (See Figure b) at the

rear of the grill’s body ❺ (See Figure a). Press the upper lock button ❹ to

remove the upper removable plate ❼, and then press the lower lock button ❹

to remove the lower removable plate ❻ by simply pulling it. Wash the

removable plates in warm soapy water, and then wipe them dry with a soft

cloth. These parts can also be washed in the dishwasher. Please note that

plates should be washed and dried after each cooking operation. Install both

the upper and the lower grill plates back in place before use. Put the grill on a

flat and stable heat-resistant surface.

NOTE that removable plates are interchangeable and reversible. One surface

of the plate is ribbed, and the other is flat. Food products can be cooked on any

of the above surfaces. While installing, make sure that the drip tray drain ❿ is

facing backwards, because the grease must be drained away into the drip tray

❽. When used for the first time, removable plates shall be oiled with a thin

layer of cooking oil using a paper towel. If necessary, oil the surface again to

ensure proper operation of the non-stick coating. For the first time, the device