Home
Главная
Brayer
Термопоты
1093BR-RD
Инструкция по эксплуатации Страница: 8

Brayer 1093BR-RD Инструкция по эксплуатации онлайн [8/52] 793371

- « » - the thermopot ask is lled with water by

3/3 of its capacity.

- « » - the thermopot ask is lled by 2/3 of its

capacity.

- « » - low water level, the thermopot ask is lled

by 1/3 of its capacity, it is necessary to ll the

thermopot ask with water, otherwise the heating

element will not switch on.

• Press the button (12) «Start/re-boil» on the control

panel (5), the indicator of the button (12) «Start/re-

boil» will light up, the symbol (27) « » and the

symbol (18) « » will light up, water will start heating

up, the water temperature is shown with digital

symbols (19).

Notes:

- every pressing of buttons on the control panel (5)

is accompanied by a sound signal;

- when switching on for the rst time, a foreign

smell from the heating element can appear, this is

acceptable and it is not covered by warranty.

• The hot water keeping temperature will be shown

with digital symbols (20), the hot water keeping

temperature «85°C» is set by default.

• To avoid su󰀨ering hot steam burns, do not bend

over the steam release openings (11) located in the

thermopot lid (9). Do not block the steam release

openings (11) with any objects.

• After water boiling the symbol (27) «

» will be

ashing for 60 seconds, then it will go out, you will

hear sound signals, the indicator of the button (12)

«Start/re-boil» will go out as well, the thermopot will

switch on in the keep warm mode, the hot water

keeping temperature «85°C» is set by default.

• Drain the water after the rst boiling. Hot water

resulting from the rst boiling is not recommended to

consume, you may use it for domestic needs.

ATTENTION!

Be careful during pouring out water to avoid

su󰀨ering hot water burns.

• Unlock the activation of the water dispense pump

by pressing the button (15) «Lock», illuminations of

buttons (15) «Lock» and (14) «Water dispense» will

light up.

• Place the cup on the grid (2) and press and hold the

button (14) «Water dispense», once the cup is lled

with the necessary quantity of water, release the

button (14) «Water dispense».

Notes:

- the water is dispensed only when the indicators

of the buttons (14 and 15) are switched on; if

you pressed the button (15) «Lock» and did not

perform any actions, in this case the indicators of

the buttons (14 and 15) will go out in 10 seconds;

- all the water level indicators (21) will be glowing

during water pouring;

Brayer 1093BR-RD Инструкция по эксплуатации онлайн [8/52] 793371

Содержание

Похожие устройства