Brayer BR4264 Руководство по эксплуатации онлайн [8/48] 796479

Brayer BR4264 Руководство по эксплуатации онлайн [8/48] 796479
8
EN
Press the lock (4) and set the handle (1) to vertical
position, make sure that the handle (1) is xed with
the lock (4).
Install the «hand vacuum cleaner» into the handle
body until the lock (5) activates.
Install the electric brush (11) (g. 1), make sure that
the brush (11) is xed with the lock (8). To remove the
electric brush (11), press the lock (8) and remove the
brush (11).
Use the electric brush (11) for cleaning rooms with
smooth oors or carpets with medium and low pile.
Notes:
- do not use the electric brush (11) if the pile length
exceeds 15 mm.
- do not run the electric brush (11) over electric
wires.
- after you nish cleaning the room with the electric
brush (11), switch the vacuum cleaner o󰀨 with the
on/o󰀨 button (2).
Using additional nozzles (20, 21)
The nozzles (20, 21) are only used when installed in
a «hand vacuum cleaner».
Press the lock (5) and remove the «hand vacuum
cleaner», insert the nozzle (20 or 21) into the air inlet
of the «hand vacuum cleaner».
To switch the «hand vacuum cleaner» on press the
button (7), the light indicator (6) will light up.
After the operation switch the «hand vacuum
cleaner» o󰀨 by pressing the button (7), the light
indicator (6) will go out.
Remove the attached nozzle (20 or 21).
Store the nozzles (20, 21) on the oor stand (15) at
the places where they should be installed (16).
BATTERY CHARGING
ATTENTION!
- Use only the battery supplied with the unit. Using a
non-original battery can be dangerous.
- Do not expose Li-ion batteries to impacts and high
temperatures. Do not disassemble the battery to
avoid the electrolyte leakage.
- Do not throw the battery into re.
- Avoid the battery terminals circuit, it may cause
burns or re.
- Do not discard the battery with usual household
waste, apply to a specialized center for further
recycling.
Before using the unit for the rst time or after a long
period of inactivity, charge the battery.
Install the vacuum cleaner into the oor stand (15).
Plug the power adapter (18) plug (19) into the socket
(17) of the oor stand (15).
Insert the power adapter (18) into the power socket,
the indicator (6) will light up and start ashing, when
the battery (9) is fully charged, the indicator (6) will
be permanently lit up.

Содержание

Скачать