Timberk N30 50л. T-WSS50-N30-V Инструкция по эксплуатации онлайн [29/60] 800996

IM2022

magnesium anode must be checked (degree of breakdown) in order to have it replaced

with a new one in case of complete breakdown. Tank cleaning frequency depends on

the hardness of water in the area.

WARNING!

The manufacturer offers an extended warranty on individual components of the water

heater, provided that timely and proper maintenance is performed by specialists of the

Authorized Service Center (ASC), see the warranty card.

4. Preventive maintenance must be conducted in strict compliance with the operating

manual and safety precautions.

5. The heater is equipped with a thermal switch, which will disconnect power supply to

the heating element if the water in the tank is overheated. If the water heater is

plugged in, but the water is not heated and the indicator is not on, the thermal switch

has either turned off or not been turned on. To reset the water heater back to operating

condition, you must:

- Disconnect power from the water heater, remove the bottom cover cap;

- Press the button located in the center of the thermal switch (round shape, near the

heating element) until you hear a click, see Fig. 6;

- If the button cannot be pressed and there is no click, wait until the thermal switch

cools to the initial temperature.

After resetting the thermal switch back to operating condition, perform the above steps

in reverse order.

WARNING!

In case no positive effect has been achieved or the thermal switch turns off repeatedly

within a short period of time, the power supply and water supply to the water heater

should be disconnected, and your local ASC should be contacted for advice or product

repair.

6. To drain the internal tank, use the safety relief valve: unscrew the screw of drain

knob on the safety relief valve and move the drain knob to the up position — the hot

water outlet tap must be open and the cold water inlet tap must be closed (see Fig. 5).

Water will start flowing from the pressure relief port of the safety relief valve.

WARNING!

Never drain water if its temperature is above 50 °C, as this may cause burns.

7. Remember to check that the safety relief valve is operable every 14 days. Check it

as follows: