Home
Главная
Brayer
Машинки Для Стрижки
BR3430
Руководство по эксплуатации Страница: 9

Brayer BR3430 Руководство по эксплуатации онлайн [9/44] 808329

9EN

• For even haircut make sure that the attachment

comb ts closely to the head.

• Slowly run the hair clipper through the hair, moving it

in di󰀨erent directions, make overlapping movements

to make sure that all areas of the hair on the head

are trimmed.

• Comb the hair along the direction of the growth to

make it easier to cut them with the clipper.

• For even haircut of wavy, thin or long hair, use the

comb to direct the hair to the blade block (1, 2).

• From time to time clean the attachment comb from

cut hair with the brush (13).

STEP ONE (FIG. 7, 8)

• Install the attachment comb (9 or 10). Switch the hair

clipper on by moving the switch (5) to the position

«I». Hold the hair clipper with the blades pointed

upwards. Start cutting from the hair growth edge.

Slowly move the hair clipper upwards. Cut the back

of the head area at the bottom and near the ears.

STEP TWO (FIG. 9)

• Switch the hair clipper o󰀨, then set the attachment

comb (11), switch the hair clipper on and continue

cutting hair near top of the head.

STEP THREE (FIG. 8)

• Switch the hair clipper o󰀨, set the attachment comb

(8 or 9) for shorter hair and cut hair on the temples.

Switch the hair clipper o󰀨, then set the attachment

comb (10 or 11), switch the hair clipper on and

continue cutting hair towards the top of the head.

STEP FOUR (FIG. 10)

• Cut the hair from the top of the head towards the

crown against the hair growth direction.

• Use the attachments (8 or 9) for short haircut

(3-6 mm). To leave slightly longer hair use the

attachments (10 or 11) (9-12 mm).

• To leave longer hair, take hair locks between your

ngers and cut it using the hair clipper. Lift the hair

locks with the comb and cut them along the comb.

• Comb the hair to reveal uneven locks.

STEP FIVE (FIG.11)

• In the nal stage of hair styling remove the installed

attachment comb (8, 9, 10, 11) from the clipper,

turn the blades of the clipper towards the hair and

trim hair on the temples and neck carefully. Before

creating the contour, comb the hair above ears.

Slightly bend back the person’s ear so it will not get

in the way of cutting hair. Do not press the clipper

strongly, there is danger of injuries or cuts when open

blades come in contact with skin.

• Note: without using the attachment combs (8, 9,

10 or 11) for a short haircut you can change the

remaining hair length up to 3 mm, to change the

remaining hair length use the regulator (3) for the

length of the hair to be left (g. 5).

Brayer BR3430 Руководство по эксплуатации онлайн [9/44] 808329

Содержание

Похожие устройства