Home
Главная
Brayer
Кофеварка
BR1113
Инструкция по эксплуатации Страница: 10

Brayer BR1113 Инструкция по эксплуатации онлайн [10/60] 811625

Note:

- when the steam supply is switched on, the button

(16) indicator «

» will ash periodically and

glow constantly, indicating that the water is being

heated in the boiler;

- some water or steam may appear from the lter

holder (5), it is normal.

• Put the tip (10) of the cappuccinator pipe into a glass

with cold milk or cream, carefully turn the steam

supply control knob (8) « » counterclockwise

for a quarter of a turn or more. The tip (10) should

not touch the bottom of the glass, as this can hinder

the steam release; you can make thick frothed milk in

several seconds.

Note:

- to avoid splashing milk always immerse the tip

(16) deeper than 1 cm from the milk surface.

- when selecting a cup for milk or cream, keep

in mind that the frothed milk amount increases

approximately twice.

• The outgoing steam creates whirls which froths milk;

from time to time lift and lower the bowl with milk

against the tip (10) to make the milk foam.

• Making the milk foam is an art. You may not make it

at the rst try, don’t worry and experiment until you

achieve good results.

• You can remove the tip (10) and try to froth the milk

with the steam released from the cappuccinator pipe

(9).

- If you need to promptly remove the lter holder

(4), you have to reduce the pressure in the boiler,

switch the co󰀨ee maker o󰀨 by pressing the on/o󰀨

button (14) «

», place a suitable cup under

the tip (10) and slightly open the steam supply by

turning the knob (8) «

» counterclockwise.

After the pressure in the boiler is released, you

can remove the lter holder (4).

- repeated making of co󰀨ee should be performed

after at least 5 min interval.

MAKING CAPPUCCINO

ATTENTION!

Be careful to avoid burns by the released hot steam.

• Make an espresso co󰀨ee using a cup that has room

to add milk froth.

• Make sure that the steam control knob (8) «

» is

in the utmost position «●».

• Press the steam supply button (16) «

» and wait

until the button (16) indicator glows constantly.

Place any suitable bowl under the tip (10) for water.

Carefully turn the steam supply knob (8) « »

counterclockwise for a quarter of a turn to remove the

condensed uid from the cappuccinator pipe (9).

• After removing the condensed uid close the steam

supply by turning the knob (8) « » clockwise

until bumping «●».

Brayer BR1113 Инструкция по эксплуатации онлайн [10/60] 811625

Похожие устройства