Home
Главная
Brayer
Кофеварка
BR1117
Инструкция по эксплуатации Страница: 14

Brayer BR1117 Инструкция по эксплуатации онлайн [14/68] 811626

12. Press the steam supply button (18) « » and wait

until the button (18) lighting «

» stops ashing and

glows constantly. Put a suitable bowl under the tip

(11) and slightly open the steam supply by turning

the knob (9) «

» counterclockwise. Carefully turn

the handle (9) «

» to the maximum steam release

position, the steam release time is limited to 65

seconds, close the steam by turning the handle (9) «

» clockwise until bumping «0».

13. Switch the co󰀨ee maker o󰀨 by pressing the on/o󰀨

button (15) « »,. Wait for 10-15 minutes.

14. Perform the steps 10 and 11 at least 3 times.

15. Repeat the cleaning procedure for the steam release

channels described in the paragraph 12.

16. With small intervals, repeat the boiler cleaning

procedure (paragraph 10) until the citric acid solution

dissolves in the tank (14) completely.

Note: to reset the co󰀨ee maker operating cycles, after

cleaning the co󰀨ee maker from mineral deposits, in

standby mode, simultaneously press and hold the water

supply button for one cup (16) « » and the steam supply

button (18) «

» for 3 seconds, the illumination of all four

buttons on the control panel (7) will ash three times, the

number of co󰀨ee maker operating cycles will be reset to

zero.

17. Switch the co󰀨ee maker o󰀨 by pressing the on/o󰀨

button (15) «

».

2. Make sure that the steam supply is closed. To do this

turn the knob (9) «

» clockwise until bumping «0».

3. Make citric acid solution: 2 teaspoons of acid to 1

litre of water and pour the solution into the water tank

(14). Install the tank (14) back to its place.

4. Insert one of the co󰀨ee lters (6) into the holder (5).

Do not put ground co󰀨ee into the lter (6).

5. Install the lter holder (5) into the co󰀨ee maker. The

holder (5) ledges should match the grooves on the

boiler « », after that turn the lter holder handle (4)

to the right until bumping « » (pic. 1).

6. Place a suitable cup on the grid (2).

7. Insert the power plug into the mains socket.

8. Switch the co󰀨ee maker on by pressing the on/o󰀨

button (15) « », the button (15) lighting will light up

and ash, when the button (15) lighting stops ashing

and glows constantly, this means that the preheating

is completed.

9. Press the button (17) «

», after the pump switches

o󰀨, press the button (17) «

» again, it is necessary

to pour water out of the boiler and ll it with citric acid

solution. Pour the liquid out of the cup.

10. Wait for a few minutes, then switch the water supply

on by pressing the button (17) «

», after the pump

switches o󰀨, press the button (17) «

» again, pour

the liquid out of the cup.

11. After a while repeat the procedure described in the

paragraph 10.

Brayer BR1117 Инструкция по эксплуатации онлайн [14/68] 811626

Похожие устройства