Home
Главная
Weldy
Сетевые
energy HT1600 D 160.172
Инструкция к товару Страница: 4

Weldy energy HT1600 D 160.172 Инструкция к товару онлайн [4/56] 815084

Original Operating Manual

Warning

DANGER! Danger when opening up the tool, as live components and

connections are exposed. Therefore, before opening it, unplug the tool

to ensure disconnection from the mains.

Before

putting into operation,

check power supply cord and connector as well as extension cable for

electrical and mechanical damage.

Incorrect use of the Hot Air Tool (eg. overheating of the material) can

present a ﬁre and explosion hazard, especially near combus t ible

materials and explosive gases.

Do not touch the heating element housing and air nozzle

when

they are hot as they can cause burns. Let the tool cool down. Do

not point the hot air flow in the direction of people or animals.

Attention

The voltage rating stated on the tool must correspond to the mains

voltage.

For personal protection on building sites we strongly recommend

the tool be connected to a RCCB (Residual Current Circuit Breaker).

The tool must be operated under supervision. Heat can ignite ﬂam-

mable materials which are not in view. The machine may only be used

by qualiﬁed specialists or under their supervision. Children are not

authorized to use this machine.

Protect tool from damp and wet.

Repairs should only be carried out by authorized service points.

Restricted to use with original Weldy accessories and spare parts.

Warranty

• For this tool, the guarantee or warranty rights granted by the relevant distri-

butor/seller shall apply. In case of guarantee or warranty claims any manu-

facturing or workmanship defects will either be repaired or replaced by the

distributor at its discretion. Warranty or guarantee rights have to be veriﬁed by

an invoice or a delivery document. Heating elements shall be excluded from

warranty or guarantee.

• Additional guarantee or warranty claims shall be excluded, subject to mandato-

ry provisions of law.

• Warranty or guarantee shall not apply to defects caused by normal wear and

tear, overload or improper handling.

• Warranty or guarantee claims will be rejected for tools that have been altered

or changed by the purchaser.

Conformity

Leister Technologies AG

, Galileo-Strasse 10, 6056 Kaegiswil/Switzerland,

conﬁrms that these products, in the version as brought into circulation through

us, fulﬁls the requirements of the following EC directives.

Directives:

2006/42, 2014/30, 2014/35, 2011/65

Harmonized

EN 12100, EN 55014-1, EN 55014-2, EN 61000-3-2

Standards:

EN 61000-3-3, EN 62233, EN 60335-2-45, EN 50581

Kaegiswil, 31.07.2017

Bruno von Wyl, CTO Christoph Baumgartner, GM

Applications

This hot-air tool is intended for all of the hot-air applications listed here, subject to compliance with safety regulations and the utilization of original Weldy accessories:

• Welding of all thermoplastic synthetic materials • Shrinkage & forming of thermoplastic synthetic materials • Drying of watery-moist surfaces

• Welding of foils & plastic sheeting • Activation/detaching of solvent-free adhesives & hot melt adhesives • Soldering of copper pipes, solder connectors & metal foils

Weldy energy HT1600 D 160.172 Инструкция к товару онлайн [4/56] 815084

Похожие устройства