Oleo-Mac газонокосилка аккумуляторная GI 44 T с АКБ и ЗУ + воздуходувка аккумуляторная BVI 60 без АКБ и ЗУ 5415-9001S1+5406-9001 Инструкция к воздуходувке онлайн [46/290] 815413

WARNING

For your safety and the safety of others:

• After each use, remove the battery from its housing and check for any damage.

• Proper maintenance is essential to maintain the original good working order and

safety of the machine over time.

• Keep nuts and screws tightened, to make sure the machine is always in safe

working conditions.

• Never use the machine with worn or damaged parts. Damaged parts must

always be replaced and never repaired.

• Only use original spare parts. Parts that are not of the same quality could

damage the machine and harm safety.

WARNING

During maintenance operations, remove the battery from its housing.

Inspect the tool before each use to check for worn or damaged components. Do not use the

chain saw if you notice any broken or excessively worn parts.

9.1.1 Engine cooling

To avoid overheating and damaging the motor, the cooling air intake grilles must always be

kept clean and free from leaves and debris.

9.1.2 Managing the battery

1. The battery must be stored in environments with temperatures between 0℃ and +45℃. If

storing the machine in places where these limits could be exceeded, remove the battery and

store it in a suitable place.

2. During use, the battery is protected against total discharge by a protective device that

switches off the machine and stops its operation.

3. The battery comes with a protective device that prevents recharging if the ambient

temperature is not between 0℃ and +45℃.

4. The battery can be recharged at any time, even partially, without the risk of damaging it.

9.1.3 Storage

At the end of each work session, thoroughly clean the machine of dust and debris, repair or

replace defective parts.

The machine must be stored in a dry place, protected from bad weather and out of reach of

children.

9.1.4 Maintenance table

The following is a list of the maintenance operations that must be carried out on the machine.

Most entries are described in section 9.1 ROUTINE MAINTENANCE. The user must perform only