Ada Cosmo 120 video с адаптером Leica TA360 А00502_К Инструкция к товару онлайн [4/22] 818775

COSMO 120

VIDEO

11. Additional calculations

12. Main result

13. Reference point

Display in Digital Camera mode

Built-in digital camera shows the target directly on the

display.

The instrument takes measurements with the help of

crosshairs, even if the laser dot is not visible (in bright

illumination).

The brightness of the display can be adjusted with and

buttons.

When the digital camera is used for close targets (<10m) the

laser dot may not coincide with the image in the center of

the display. In this case you should rely on the actual laser

dot for targeting the object.

Inserting / Replacing Batteries

Remove the battery compartment lid.

Insert the batteries. Pay attention to the polarity.

Close the battery compartment.

The batteries should be replaced, when the battery voltage

is too low.

Batteries should be removed if the device will not be used

for a long time (danger of corrosion).

Use alkaline or Li-batteries.

NOTE:

We reccomend to use LI /IRON Batteries (energy-plus bat-

tery). Approximate time of continious operation*:

• LI / IRON (4 000 mAh) - about 5 hours

• NiMh (2 000 mAh) - about 3.5 hours

*in condition of operation under environment temperature

20°C and also average values of instrument settings (bright-

ness, contrast and so on).

Laser classication

The instrument is a laser class 2 laser product with power

< 1 mW and wavelength 635 nm. Laser is safety in ordinary

conditions of usage.

Reference point

Always select the reference point before the measurements.

Press button (5) to select the reference point. The reference

point can be: back part, front part, end-piece, thread for the

tripod. Selected point is displayed on the display by the icon