Levenhuk Wezzer PLUS LP20 78892 Инструкция к товару онлайн [5/49] 821689

Levenhuk Wezzer PLUS LP20 Thermohygrometer

The kit includes: base station, 3 sensors, user manual, and warranty.

Also required (not included):

2 AAA batteries for each sensor

2 AA batteries for the base station

Getting started

Base station

• Open the battery compartment cover (13) and insert 2 batteries according to the correct

polarity. Close the cover.

• Wait until the indoor temperature is displayed on the base station.

Sensor

• Open the battery compartment cover (8). Set the desired channel with the switch.

NOTE! This weather station can be operated with up to 3 remote sensors. Each remote

sensor that is to be connected must be operated on a dierent channel. If only one

remote sensor is connected, it should be operated on channel 1.

• Insert 2 batteries according to the correct polarity. Close the cover.

• To re-establish the sensor connection manually, press RESET using a pin.

Sensor connection

• Place the base station and the remote sensor within the eective transmission range. Ensure

that the channels are assigned after you set up the power supply for the base station and all the

sensors.

• If the reception is successful, the display will show the temperature and humidity of the

respective outdoor sensor. If the values are not received from a channel, "—" appears on the

display. Check the batteries and try it again. Check if there is any source of interference.

• When changing batteries, replace the batteries rst in the base unit, and then in all the sensors,

to re-establish the connection. If an adapter supplies power to any of the devices, briey

disconnect the power to that device when replacing the batteries. If you change the batteries

only in one of the devices (for example, in the sensor), the signal may not be received correctly.

• The eective range may dier depending on the unit’s position. Due to interference (various

remote control devices, etc.), the maximum distance between the base unit and the sensor

may be signicantly reduced. In such cases, we suggest moving the base unit and sensor a little.

Sometimes it is enough to move one of these units a few inches!

NOTE! Although the sensor is weather resistant, never place it in direct sunlight or in the

rain or snow.