Levenhuk Wezzer PLUS LP50 78895 Инструкция к товару онлайн [4/48] 821690

Levenhuk Wezzer PLUS LP50 Weather Station

The kit includes: base station, 3 sensors, user manual, and warranty.

Also required (not included):

2 AAA batteries for each sensor

3 AAA batteries for the base station

Getting started

Base station

• Open the battery compartment cover (11) and insert 3 batteries according to the correct polarity. Close the

cover.

• Wait until the indoor temperature is displayed on the base station.

Sensor

• Open the battery compartment cover (8). Set the desired channel with the switch.

• Insert 2 batteries according to the correct polarity. Close the cover.

• To re-establish the sensor connection manually, press RESET using a pin.

Sensor connection

• Place the base station and the remote sensor within the eective transmission range. Ensure that the channels

are assigned after you set up the power supply for the base station and all the sensors.

• If the reception is successful, the display will show the temperature and humidity of the respective outdoor

sensor. If the values are not received from a channel, "—" appears on the display. Check the batteries and try it

again. Check if there is any source of interference.

• When changing batteries, replace the batteries rst in the base unit, and then in all the sensors, to re-establish

the connection. If an adapter supplies power to any of the devices, briey disconnect the power to that device

when replacing the batteries. If you change the batteries only in one of the devices (for example, in the

sensor), the signal may not be received correctly.

• The eective range may dier depending on the unit’s position. Due to interference (various remote control

devices, etc.), the maximum distance between the base unit and the sensor may be signicantly reduced. In

such cases, we suggest moving the base unit and sensor a little. Sometimes it is enough to move one of these

units a few inches!

Time setting

Press the SET button and hold it for 3 seconds. The digits that are to be set are ashing. Press UP or DOWN to

change the value, and then press SET to continue.

The setting order: Hours > Minutes > Year > Date/Month or Month/Date format > Month > Date > Atmospheric

pressure (hPa/mmHg/mb).

NOTE! This weather station can be operated with up to 3 remote sensors. Each remote sensor that is

to be connected must be operated on a dierent channel. If only one remote sensor is connected, it

should be operated on channel 1.

NOTE! Although the sensor is weather resistant, never place it in direct sunlight or in the rain

or snow.