Levenhuk Wezzer PLUS LP60 78896 Инструкция к товару онлайн [6/50] 821691

Levenhuk Wezzer PLUS LP60 Weather Station

The kit includes: base station, 3 sensors, USB cable, user manual, and warranty.

Also required (not included):

2 AAA batteries for each sensor

3 AAA batteries for the base station

Getting started

Base station

• Connect the power cable to the device and the DC adapter (not included) via a USB plug

and connect to the AC power supply; or

• Open the battery compartment cover (6) and insert 3 batteries according to the correct

polarity. Close the cover.

• Wait until the indoor temperature is displayed on the base station.

Sensor

• Open the battery compartment cover (1). Set the desired channel with the switch.

• Insert 2 batteries according to the correct polarity. Close the cover.

• To re-establish the sensor connection manually, press RESET using a pin.

Sensor connection

• Place the base station and the remote sensor within the eective transmission range.

Ensure that the channels are assigned after you set up the power supply for the base

station and all the sensors.

• If the reception is successful, the display will show the temperature and humidity of the

respective outdoor sensor. If the values are not received from a channel, "—" appears

on the display. Check the batteries and try it again. Check if there is any source of

interference.

• When changing batteries, replace the batteries rst in the base unit, and then in all the

sensors, to re-establish the connection. If an adapter supplies power to any of the devices,

briey disconnect the power to that device when replacing the batteries. If you change

the batteries only in one of the devices (for example, in the sensor), the signal may not be

received correctly.

• The eective range may dier depending on the unit’s position. Due to interference

(various remote control devices, etc.), the maximum distance between the base unit and

the sensor may be signicantly reduced. In such cases, we suggest moving the base unit

and sensor a little. Sometimes it is enough to move one of these units a few inches!

Caution! Please remember that mains voltage in most European countries is 220—240V. If you

want to use your device in a country with a dierent mains voltage standard, remember that use

of a converter is absolutely necessary.

NOTE! This weather station can be operated with up to 3 remote sensors. Each remote sensor

that is to be connected must be operated on a dierent channel. If only one remote sensor is

connected, it should be operated on channel 1.

NOTE! It is recommended to use an adapter for the continuous operation of the base station,

although battery power is also possible.