Contracor 10112730 Инструкция по эксплуатации онлайн [6/24] 825870

CONTRACOR

Version 6.2

2. Set-up of device

Set the PBT-2 ROTOBLAST device on a hard level surface.

Loosen the locking nut (28) and unscrew the rubberized pipe (35) by 5-10 mm.

Turn the rotating head (30) 5-6 resolutions by hand, which should rotate freely.

Fit the abrasive blast nozzles to the rotating head (30).

Tighten the rubberized pipe (35) by hand all the way.

Check rotation of the rotating head (30) by hand. The head should be turnable with one

hand, but with considerable effort.

Connect the compressed-air hose to the inlet CFT coupling.

Put on all sandblast operator personal protective wear and prepare for operation.

Holding the PBT-2 ROTOBLAST tightly, gently feed compressed air at the working volume

and pressure.

Check that there is no discharge of compressed air through the control ports of the bush-

ing (6). If there is leakage of compressed air, see point No.6.

Gently loosen the rubberized pipe (35) until the rotating head (30) starts to rotate by itself.

Try to rotate the head (30) within the range of 1-2 revolutions per second.

Repeat point 10.

Stop the feed of compressed air to the PBT-2 ROTOBLAST device.

Without moving the position of the rubberized pipe (35), tighten the locking nut (28).

Set the legs to the required length.

Connect the front and rear parts to the PBT-2 ROTOBLAST.

The device is ready for operation.