Home
Главная
Hilti
Монтажные (отрезные)
DCH 300-X 230V 2149600
Инструкция к товару Страница: 16

Hilti DCH 300-X 230V 2149600 Инструкция к товару онлайн [16/108] 829120

10 English 2149875

*2149875*

4.4 Dimensions and format of suitable diamond cutting discs

Diamond cutting discs must meet the following require-

ments in terms of dimensions and format.

Technical data

Slot width between segments

(G)

≤ 10 mm

Cutting angle Negative

5 Operation

5.1 General information

5.1.1 Using a generator or transformer

This tool may be powered by a generator or transformer when the following conditions are fulfilled:

• The power output of the generator or transformer (in watts) must be at least twice the power rating of the

tool (see type identification plate).

• The voltage provided by the power source must remain within +5 % and –15 % of the tool’s rated

voltage.

• Frequency: 50 to 60 Hz (never above 65 Hz)

• The power source must be equipped with automatic voltage regulation and starting boost.

ATTENTION

Risk of damage Switching on or switching off other power tools or appliances connected to the generator

or transformer may cause undervoltage and/or overvoltage peaks, resulting in damage to the cutter.

▶ Never operate other power tools or appliances from the generator or transformer at the same time. Where

applicable, use a generator or transformer designed for simultaneous operation of the cutter and vacuum

cleaner.

5.1.2 Use of extension cords

WARNING

A damaged supply cord presents a hazard! Do not touch the supply cord or extension cord if damaged

while working. Disconnect the supply cord plug from the power outlet.

▶ Check the appliance’s supply cord at regular intervals and have it replaced by a qualified specialist if

found to be damaged.

• Use only extension cords of a type approved for the application and with conductors of adequate

cross-section. Otherwise the performance of the appliance may be affected and the cord may overheat.

• Regularly check the extension cord for damage.

• Replace damaged extension cords.

• When working outdoors, use only extension cords that are approved and correspondingly marked for

this application.

Recommended minimum conductor cross-sections and maximum power cord lengths for 120V sup-

ply voltage

Power cord AWG 16 AWG 14 AWG 12 AWG 10

Conductor cross-section 1,31 mm² 2,08 mm² 3,31 mm² 5,26 mm²

Conductor cross-section 2,58 kcmil 4,11 kcmil 6,53 kcmil 10,4 kcmil

Power cord length 25 m 30 m 50 m 100 m

Power cord length 75 ft 100 ft 150 ft 250 ft

Printed: 23.10.2018 | Doc-Nr: PUB / 5459237 / 000 / 00

Hilti DCH 300-X 230V 2149600 Инструкция к товару онлайн [16/108] 829120

Похожие устройства