Hilti DCH 300-X 230V 2149600 Инструкция к товару онлайн [21/108] 829120
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Hilti DCH 300-X 230V 2149600 Инструкция к товару онлайн [21/108] 829120

Hilti DCH 300-X 230V 2149600 Инструкция к товару онлайн [21/108] 829120
*2149875*
2149875 English 15
Trouble or fault Possible cause Action to be taken
The power tool doesn’t start
or switches itself off.
Interruption in the electric supply. ▶ Check the electric supply
by connecting a different
appliance.
The portable residual current de-
vice (PRCD) has tripped because
of water ingress into the power
tool.
▶ Leave the power tool in a warm,
dry place until it has thoroughly
dried.
▶ Check the portable residual
current device. → page 11
The supply cord or plug is defec-
tive.
▶ Have the supply cord and plug
checked by a trained electrical
specialist and replaced if
necessary.
The on / off switch is defective. ▶ Have the power tool repaired by
Hilti Service.
The power tool has been
overloaded (overload protection
activated / application limits
exceeded).
▶ Release the on/off switch and
then press it again.
▶ Select a suitable power tool for
the application.
The overheating protection system
is active.
▶ Allow the power tool to cool
down and clean the air vents.
The restart interlock is active after
disconnection or an interruption in
the electric supply.
▶ Switch the power tool off and
then on again.
The service indicator blinks.
The power tool doesn’t start.
The power tool is faulty. ▶ Have the power tool repaired by
Hilti Service.
The service indicator lights.
The power tool doesn’t start.
The carbon brushes are worn. ▶ Have the carbon brushes
checked by a trained electrical
specialist and replaced if
necessary.
The tool doesn’t achieve full
power.
The extension cord conductor
cross section is too small.
▶ Use an extension cord with
conductors of adequate cross
section.
9 Disposal
Most of the materials from which Hilti products are manufactured can be recycled. The materials must be
correctly separated before they can be recycled. In many countries, your old tools, machines or appliances
can be returned to Hilti for recycling. Ask Hilti Service or your Hilti representative for further information.
In accordance with the European Directive on waste electrical and electronic equipment and its implemen-
tation in conformance with national law, electric tools or appliances that have reached the end of their life
must be collected separately and returned to an environmentally compatible recycling facility.
▶ Disposal of electric tools or appliances together with household waste is not permissible.
Cutting slurry
The disposal of cutting slurry directly into rivers, lakes or the sewerage system without suitable pretreatment
presents problems of an environmental nature.
▶ Ask the local public authorities for information about current regulations.
We recommend the following pretreatment:
▶ Collect the cutting slurry (for example, using a wet-type vacuum cleaner).
▶ Allow the slurry to stand for some time or add a flocculation agent to help the fine particles in the cutting
slurry settle and separate from the water.
▶ Dispose of this solid portion of the waste at a construction waste disposal location.
▶ Neutralize the remaining water from the cutting slurry (alkaline, pH-value > 7) by adding an acidic
neutralizing agent or dilute it by adding a large quantity of water before allowing it to enter the sewerage
system.
Printed: 23.10.2018 | Doc-Nr: PUB / 5459237 / 000 / 00

Похожие устройства

Скачать