Hilti DSH 900-X 40 2265863 Инструкция к HILTI DSH 900-X 40 2265863 онлайн [46/492] 830938
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Hilti DSH 900-X 40 2265863 Инструкция к HILTI DSH 900-X 40 2265863 онлайн [46/492] 830938

Hilti DSH 900-X 40 2265863 Инструкция к HILTI DSH 900-X 40 2265863 онлайн [46/492] 830938
38 English 2271384
*2271384*
8.1 Transportation in a vehicle
WARNING
Risk of fire and explosion. If the product tips over during transport, fuel may run out of the fuel tank.
▶ Empty the product’s fuel tank completely before packing and shipping it.
▶ Transport the product, as far as possible, in its original packaging.
WARNING
Fire hazard. Hot parts of the machine could ignite material lying about in the surrounding area.
▶ Allow the product to cool down completely before packing it away or loading it into a vehicle..
1. Remove the cut-off wheel.
2. Secure the product to prevent it falling over, thereby causing damage or fuel spillage.
3. Transport the saw trolley only when the water tank has been emptied.
8.2 Storing the fuel mixture
CAUTION
Risk of injury. As pressure may build up in the fuel tank there is a risk of fuel being forced out when the fuel
cap is opened.
▶ Always open the cap of the fuel tank carefully so that the pressure is relieved gradually.
▶ Store the fuel in a dry, well-ventilated room.
1. Mix only enough fuel for a few days’ use.
2. Clean the fuel container occasionally.
9 Troubleshooting
Trouble or fault Possible cause Action to be taken
Cut-off wheel slows down
or stops completely while
cutting.
Excessive cutting pressure applied
(cut-off wheel stalls in the kerf)
or pressure applied to the cut-off
wheel from the side.
▶ Reduce pressure when cutting
and guide the product in a
straight line.
The cut-off wheel is not correctly
fitted and tightened.
▶ Check how it is fitted and the
tightening torque.
Wrong direction of rotation. ▶ Fit the cut-off wheel. → page 30
The forward section of the saw arm
is loose.
▶ Have the product repaired by
Hilti Service.
High vibration, wheel wanders
off the cutting line.
The cut-off wheel is not correctly
fitted and tightened.
▶ Check how it is fitted and the
tightening torque.
Cut-off wheel is damaged (or un-
suitable specification, cracked,
segments missing, bent, over-
heated, deformed, etc.).
▶ Change the cut-off wheel.
The centering bushing is fitted in-
correctly.
▶ Check that the diameter of the
arbor hole in the cut-off wheel
matches the centering collar
of the cut-off wheel centering
bushing.
The saw doesn’t start or is
difficult to start.
The fuel tank is empty (no fuel in
the carburetor).
▶ Fill the fuel tank. → page 30
Air filter clogged with dirt or dust. ▶ Change the air filter.
The engine is flooded (spark plug
wet).
▶ Remove the spark plug, dry the
plug and allow the cylinder to
dry out.

Похожие устройства

Скачать