Ingersoll rand 312A Инструкция к товару онлайн [3/52] 831583

04581575_ed4 EN-1

Product Safety Information

Intended Use:

These Air Orbital Sanders are designed for smoothing and sanding paint, berglass, wood and

body ller.

For additional information refer to Product Safety Information Manual Form 04584967.

Manuals can be ingersollrandproducts.com

Product Specications

Model

Free Speed Pad Size

Sound Level dB (A)

(ISO15744)

Vibration m/s²

(ISO28927)

rpm inch mm † Pressure (L

) ‡ Power (L

) Level *K

312A 18000 3.5 X 6-1/3 88 X 165 86 97 7.7 1.5

† K

= 3dB measurement uncertainty * K = Vibration measurement uncertainty

‡ K

= 3dB measurement uncertainty

WARNING

Sound and vibration values were measured in compliance with internationally recognized

test standards. The exposure to the user in a specic tool application may vary from these

results. Therefore, on site measurements should be used to determine the hazard level in

that specic application.

Installation and Lubrication

Size air supply line to ensure tool’s maximum operating pressure (PMAX) at tool inlet. Drain

condensate from valve(s) at low point(s) of piping, air lter and compressor tank daily. Install

a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any

hose coupling without internal shut-o, to prevent hose whipping if a hose fails or coupling

disconnects. See drawing 16575516 and table on page 2. Maintenance frequency is shown in a

circular arrow and dened as h=hours, d=days, and m=months of actual use. Items identied as:

1. Air lter 6. Thread size

2. Regulator 7. Coupling and anti-whip device

3. Lubricator (not if lube-free tool) 8. Safety Air Fuse

4. Emergency shut-o valve 9. Oil (not if lube-free tool)

5. Hose diameter

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled,

degreased and parts be separated by material so that they can be recycled.

Original instructions are in English. Other languages are a translation of the original instructions.

Tool repair and maintenance should only be carried out by an authorized Service Center.

Refer all communications to the nearest Ingersoll Rand Oce or Distributor.