Home
Главная
Briggs & Stratton
БЕНЗИНОВЫЕ СНЕГОУБОРЩИКИ
1022 E 1696720
Инструкция к Briggs&Stratton 1022 E 1696720 Страница: 7

Briggs & Stratton 1022 E 1696720 Инструкция к Briggs&Stratton 1022 E 1696720 онлайн [7/212] 832275

Not for

Reproduction

4. Install the dipstick, and check the oil level. Make sure that

the oil level is at the top of the full indicator (B).

5. Carefully add oil into the engine oil fill.Do not overfill.

6. Wait one minute. Check the oil level again.

7. When the oil level touches the top of the full indicator,

install and tighten the dipstick.

Fuel Recommendations

Fuel must meet these requirements:

• Clean, unleaded gasoline.

• A minimum of 87 octane / 87 AKI (91 RON). SeeHigh

Altitude Requirements.

• Gasoline with up to 10% ethanol (gasohol).

NOTICE Do not use unapproved gasoline, such as E15

and E85. Do not mix oil in gasoline or change the engine

to operate on alternative fuels. Use of unapproved fuels

will cause damage to engine components, which will not be

covered under the warranty.

To protect the fuel system from gum formation, mix a fuel

stabilizer into the fuel. SeeStorage.All fuel is not the same.

If start or performance problems occur, change fuel providers

or change brands. This engine is certified to operate on

gasoline. The emissions control system for this engine is EM

(Engine Modifications).

High Altitude Requirements

• At altitudes over 5,000 feet (1,524 meters), a minimum 85

octane / 85 AKI (89 RON) gasoline is acceptable.

• For carbureted engines, high altitude adjustment is

required to remain emissions compliant. Operation

without this adjustment will cause decreased

performance, increased fuel consumption, and increased

emissions. Contact a Briggs & Stratton Authorized

Service Dealer for high altitude adjustment information.

• Operation of the engine at altitudes below 2,500 feet

(762 meters) with the high altitude adjustment is not

recommended.

• For Electronic Fuel Injection (EFI) engines, high altitude

adjustment is not necessary.

Add Fuel

WARNING

Fuel and its vapors are extremely flammable and explosive.

Always handle fuel with extreme care. Failure to obey these

safety instructions can cause fire or explosion, which could

result in severe burns or death.

When Adding Fuel

• Stop the engine and let the engine cool at least 3

minutes before you remove the fuel cap.

• Extinguish cigarettes, cigars, pipes, and other sources

of ignition.

• Fill fuel tank outdoors or in well-ventilated area.

• Do not overfill fuel tank. To allow for expansion of the

fuel, do not fill above the bottom of the fuel tank neck.

• Keep fuel away from sparks, open flames, pilot lights,

heat, and other ignition sources.

• Check fuel lines, tank, cap, and fittings frequently for

cracks or leaks. Replace if necessary.

• If fuel spills, wait until it evaporates before you start the

engine. DO NOT create other ignition sources.

• Use only an approved fuel container.

1. Remove unwanted material from the fuel cap area.

2. Remove the fuel cap (A,Figure5).

3. Fill the fuel tank (B)with fuel. DO NOT fill above the

bottom of the fuel tank neck (C).

4. Install the fuel cap.

Briggs & Stratton 1022 E 1696720 Инструкция к Briggs&Stratton 1022 E 1696720 онлайн [7/212] 832275

Похожие устройства