Stiga Twinclip 955 B 294568038/ST2 Инструкция к двигателю онлайн [11/109] 833563
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Stiga Twinclip 955 B 294568038/ST2 Инструкция к двигателю онлайн [11/109] 833563

Stiga Twinclip 955 B 294568038/ST2 Инструкция к двигателю онлайн [11/109] 833563
ENGLISH
HELPFUL TIPS & SUGGESTIONS
STORING YOUR ENGINE
Storage Preparation
Cleaning
Fuel
Adding a Gasoline Stabilizer to Extend Fuel Storage Life
Draining the Fuel Tank and Carburetor
OFF
OFF
OONN
FUEL VALVE LEVER
ON
CARBURETOR BOWL
GASKET
DRAIN BOLT
11
Proper storage preparation is essential for keeping your engine
trouble-free and looking good. The following steps will help to
keep rust and corrosion from impairing your engine’s function and
appearance, and will make the engine easier to start when you use
it again.
If the engine has been running, allow it to cool for at least half an
hour before cleaning. Clean all exterior surfaces, touch up any
damaged paint, and coat other areas that may rust with a light film
of oil.
Using a garden hose or pressure washing equipment can force
water into the air cleaner or muffler opening. Water in the air
cleaner will soak the air filter, and water that passes through the
air filter or muffler can enter the cylinder, causing damage.
Gasoline will oxidize and deteriorate in storage. Deteriorated
gasoline will cause hard starting, and it leaves gum deposits that
clog the fuel system. If the gasoline in your engine deteriorates
during storage, you may need to have the carburetor and other
fuel system components serviced or replaced.
The length of time that gasoline can be left in your fuel tank and
carburetor without causing functional problems will vary with
such factors as gasoline blend, your storage temperatures, and
whether the fuel tank is partially or completely filled. The air in a
partially filled fuel tank promotes fuel deterioration. Very warm
storage temperatures accelerate fuel deterioration. Fuel
deterioration problems may occur within a few months, or even
less if the gasoline was not fresh when you filled the fuel tank.
Fuel system damage or engine performance problems resulting
from neglected storage preparation are not covered under the
Distributor’s Limited Warranty
.
You can extend fuel storage life by adding a gasoline stabilizer
that is formulated for that purpose, or you can avoid fuel
deterioration problems by draining the fuel tank and carburetor.
When adding a gasoline stabilizer, fill the fuel tank with fresh
gasoline. If only partially filled, air in the tank will promote fuel
deterioration during storage. If you keep a container of gasoline
for refueling, be sure that it contains only fresh gasoline.
Add gasoline stabilizer following the manufacturer’s instructions.
After adding a gasoline stabilizer, run the engine outdoors for 10
minutes to be sure that treated gasoline has replaced the
untreated gasoline in the carburetor.
Stop the engine.
Wipe up spills immediately.
Handle fuel only outdoors.
Stop engine and keep heat, sparks, and flame away.
Gasoline is highly flammable and explosive, and you
can be burned or seriously injured when handling
fuel.
Move the fuel valve lever to the ON position. This will allow the
fuel tank to drain through the carburetor bowl.
Remove the drain bolt and gasket, and drain the carburetor bowl
fuel into an approved gasoline container.
Place an approved gasoline container below the carburetor, and
use a funnel to avoid spilling fuel.
Install the gasket and drain bolt, and tighten securely.
After draining the carburetor bowl and fuel tank, move the fuel
valve lever to the OFF position.
1.
2.
3.
1.
2.
3.
4.
5.
07/05/01 15:46:31 32Z4P600_011

Похожие устройства

Скачать