Home
Главная
Stiga
Самоходные
Twinclip 955 B 294568038/ST2
Инструкция к двигателю Страница: 15

Stiga Twinclip 955 B 294568038/ST2 Инструкция к двигателю онлайн [15/109] 833563

ENGLISH

Emission Control System Information

Source of Emissions

The U.S., California Clean Air Acts and Environment Canada

Tampering and Altering

Problems That May Affect Emissions

Replacement Parts

Maintenance

The combustion process produces carbon monoxide, oxides of

nitrogen, and hydrocarbons. Control of hydrocarbons and oxides

of nitrogen is very important because, under certain conditions,

they react to form photochemical smog when subjected to

sunlight. Carbon monoxide does not react in the same way, but it

is toxic.

Honda utilizes lean carburetor settings and other systems to

reduce the emissions of carbon monoxide, oxides of nitrogen, and

hydrocarbons.

EPA, California and Canadian regulations require all

manufacturers to furnish written instructions describing the

operation and maintenance of emission control systems.

The following instructions and procedures must be followed in

order to keep the emissions from your Honda engine within the

emission standards.

Tampering with or altering the emission control system may

increase emissions beyond the legal limit. Among those acts that

constitute tampering are:

Removal or alteration of any part of the intake, fuel, or exhaust

systems.

Altering or defeating the governor linkage or speed-adjusting

mechanism to cause the engine to operate outside its design

parameters.

If you are aware of any of the following symptoms, have your

engine inspected and repaired by your servicing dealer.

Hard starting or stalling after starting.

Rough idle.

Misfiring or backfiring under load.

Afterburning (backfiring).

Black exhaust smoke or high fuel consumption.

The emission control systems on your Honda engine were

designed, built, and certified to conform with EPA, California and

Canadian emission regulations. We recommend the use of

genuine Honda parts whenever you have maintenance done.

These original-design replacement parts are manufactured to the

same standards as the original parts, so you can be confident of

their performance. The use of replacement parts that are not of the

original design and quality may impair the effectiveness of your

emission control system.

A manufacturer of an aftermarket part assumes the responsibility

that the part will not adversely affect emission performance. The

manufacturer or rebuilder of the part must certify that use of the

part will not result in a failure of the engine to comply with

emission regulations.

Follow the maintenance schedule on page . Remember that this

schedule is based on the assumption that your machine will be

used for its designed purpose. Sustained high-load or high-

temperature operation, or use in unusually wet or dusty conditions,

will require more frequent service.

07/05/01 15:47:40 32Z4P600_015

Stiga Twinclip 955 B 294568038/ST2 Инструкция к двигателю онлайн [15/109] 833563

Похожие устройства