Тион 4S Magic 00-10027943 Инструкция онлайн [19/49] 835012

Safety

Failure to comply with these requirements may result in device breakage and/or health and

safety hazards.

The device is not intended for use by people (including children) with reduced physical,

sensory or mental capabilities or those lacking in life experience or knowledge unless

supervised or instructed by someone responsible for their safety.

Children must be supervised to ensure that they do not play with the device.

Keep the power cord out of the reach of children and pets, even when the device is off.

Keep all packaging materials (cardboard, plastic bags, etc.) out of the reach of children

and pets.

Do not try to repair the device. If any damage or possible signs of malfunction are

detected, contact the Vendor's service center for advice on the device's further

operation.

Do not carry out any alterations to the design of the device. The Vendor and

Manufacturer are not responsible for any damage that may occur due to alterations

made to the design of the device.

Do not activate the device if the power supply cord insulation or any part of the housing

is damaged.

Unplug the device before conducting any maintenance.

Failure to meet these requirements may cause the device to malfunction.

Before mounting, leave the device in a warm room for 2 hours to avoid device failure, the

formation of condensation, or damage to plastic parts after transportation or storage at

low temperatures.

Do not use in premises with temperatures below 10°С or above 35°С.

Do not use in premises with relative humidity above 80% at 35°С.

Do not use in premises with sources of steam or other significant humidity where there

is a chance of water getting directly onto the device. Such premises include swimming

pools, steam baths, saunas, restrooms and bathrooms.

Avoid prolonged exposure to direct sunlight.

Do not mount or operate without following the instructions provided in this Manual and

on the mounting template.

Before unplugging the device, turn it off using the control button and wait for a double

beep. Check again for error codes 10 minutes after the beep, then unplug the device