GRAPHITE 1500Вт, 40л 59G608 Инструкция к GRAPHITE 59G608 онлайн [16/132] 835510
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

GRAPHITE 1500Вт, 40л 59G608 Инструкция к GRAPHITE 59G608 онлайн [16/132] 835510

GRAPHITE 1500Вт, 40л 59G608 Инструкция к GRAPHITE 59G608 онлайн [16/132] 835510
16
EQUIPMENT AND ACCESSORIES
1. Suction hose – 1 pce
2. Floor attachment – 2 pcs
3. Crevice attachment – 1 pce
4. Castor – 4 pcs
5. Telescopic pipe – 1 pce
6. Dust bag – 1 pce
7. Foam membrane – 1 pce
8. Pleated lter – 1 pce
9. Support for wheels – 4 pcs
10. Adapter – 1 pce
11. Lower part of auxiliary handle – 2 pcs
12. Auxiliary handle – 1 pce
13. Bolts + special nuts – 2 sets
14. Screws – 6 pcs
PREPARATION FOR OPERATION
INSTALLATION OF WHEELS
Use of wheels facilitate transportation of the vacuum cleaner. Smaller castors located in front base facilitate
manoeuvring, while large back transport wheels provide greater stability of the vacuum cleaner.
● Release xing clamps (3) on both sides of the device and remove upper body (7) (g. A).
● Turn the tank (6), place support for wheels (10) in the base sockets (11) and x with screws (g. B).
● Install front castors (5) by pushing them into holes in the support for castors (10) (g. C).
● Install rear wheels (5) by pushing them onto axis in the support for wheels (10) (g. D).
● Turn the tank again and install upper body (7).
INSTALLATION OF ADDITIONAL HANDLE
● Place lower part of auxiliary handle (a) in the guides (15) located on the tank (6) (g. E), then secure
with included screws (g. F).
● Use bolts and special nuts (14) to join lower parts of the auxiliary handle (a) and the handle (13) (g. G).
The vacuum cleaner can be transported to the work place by rolling on castors with the use of transport
handle (1) or auxiliary handle (13).
INSTALLATION / REPLACEMENT OF PLEATED FILTER
Disconnect the tool from power supply.
● Release xing clamps (3) on both sides of the device and remove upper body (7).
● Place pleated lter (b) on the oat body (c). Ensure it is installed properly (g. H).
● Install upper body (7) and secure with xing clamps (3).
Once damaged, pleated lter must be replaced with a new one.
INSTALLATION / REMOVAL OF DUST BAG
Dry cleaning requires dust bag. Using the dust bag prevents clogging of the pleated lter and extends its
lifetime, and facilitates emptying the dirt later.
● Release xing clamps (3) on both sides of the device and remove upper body (7).
● Slide the dust bag hole onto connector pipe (d) located in the tank (6) (g. I).
● Ensure the dust bag adheres to inner wall of the tank in its whole length.
● Put upper body in place (7) and secure with xing clamps (3).
● To remove the dust bag, proceed with above procedure in reverse order.
Check lling of the dust bag regularly. When the dust bag is full, replace it with a new one.
When using the vacuum cleaner to gather materials which are not harmful to health, they can be collected
in the tank (6) directly, use of pleated lter or dust bag is not necessary.

Похожие устройства

Скачать