Greenworks 40 В 2003807 Инструкция к GreenWorks 2003807 онлайн [4/305] 835721
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Greenworks 40 В 2003807 Инструкция к GreenWorks 2003807 онлайн [4/305] 835721

Greenworks 40 В 2003807 Инструкция к GreenWorks 2003807 онлайн [4/305] 835721
English (original instructions)
EN
DE ES IT FR PT NL RU FI SV NO DA PL CS SK SL HR HU RO BG EL AR TR HE LT LV ET
3
OPERATION
For complete charging instructions,
refer to the Operator’s Manuals for your
Greenworks tools battery pack and
charger models.
NOTE: To avoid serious personal injury,
always remove the battery pack and keep
hands clear of the lock-out button when
carrying or transporting the tool.
BEFORE EACH USE CHECK THE CHAIN
TENSION
Pull the chain in the middle of the
lower side of the bar away from the
bar. The gap between the cutter in the
chain and the bar should be between
3mm - 4mm.
If you need to adjust the chain
tension, please refer to the section
“ADJUSTING THE CHAIN TENSION”
later in this manual.
TO INSTALL BATTERY PACK
See Figure 2.
Align the battery pack with the battery
compartment on the top handle saw.
Grasp the top handle saw firmly.
Push the battery pack into the battery
compartment until the latch locks into
place.
You should hear a "click" once the
battery is installed.
TO REMOVE BATTERY PACK
See Figure 2.
Press the battery release button on
the battery.
Grasp the top handle saw firmly, and
pull the battery pack out of handle.
CHECKING THE CHAIN LUBRICANT
See Figure 1.
Check the amount of oil in the top
handle saw by looking at the oil level
gauge. If the oil level is low, follow
the steps shown in section “ADDING
CHAIN & BAR LUBRICANT” of this
manual.
WARNING
Check the chain tension before each use
of the saw.
WARNING
Never operate the top handle saw with-
out sufcient chain lubrication as this
might damage the saw and is a threat
to safety. Check the chain lubricant level
before each use!
In order to prevent kickback, please follow
these safety instructions:
Never cut with the tip of the guide
bar! Be careful when continuing from
previous cuts.
Always start cutting only when the top
handle saw is already running.
Make sure that the saw chain is always
properly sharpened.
Never cut through more than one
branch at a time! When lopping off
branches, be careful not to touch any
other branches.
When cross-cutting, pay attention to
trunks standing very close to each
other. If possible, use a sawing trestle.
HOLDING THE TOP HANDLE SAW
See figure 8
Grip both handles with the thumbs and the
fingers around. Ensure that your left hand
is holding the front handle so that your
thumb is underneath.
STARTING OPERATION
Before starting for operation, you
should install the battery pack in the
machine.

Похожие устройства

Скачать