Ryobi RLM46173 5133002552 Инструкция к Ryobi RLM46173 5133002552 онлайн [14/332] 840570

English

TROUBLESHOOTING

Problem Possible cause Solution

Handle not in

correct position.

Handle positioned incorrectly. Check to be sure that the pin of the lower handle

snapped into proper position.

Quick-release knobs not tightened. Tighten handle quick-release knobs.

Mower does not

start

No spark. Use spark tester to check for proper spark plug

operation.

No petrol. Fill mower with petrol. If mower still does not start,

contact a servicing dealer.

Engine is ﬂ ooded. Wait 15 minutes, then try starting mower again. Do not

prime before attempting to start.

Starter rope pulls harder now than

when new.

Contact a servicing dealer.

Mower is hard to

push.

High grass, rear of mower housing

and blade are dragging in heavy

grass, or cutting height too low.

Raise the cutting height.

Wheel assembly needs cleaning. Clean wheel assembly.

Mower is vibrating

at higher speed.

Blade is unbalanced. Replace the blade.

Bent motor shaft. Stop the engine, disconnect the spark plug wire from

the spark plug, and inspect for damage. Have it repaired

by an authorised service center before restarting.

Mower is not

mulching properly.

Wet grass clippings are sticking to

the underside of the deck.

Wait until the grass dries before mowing. Clean the

underside of the mower deck.

Mower is not

bagging properly.

Cutting height set too low. Raise the cutting height.