Felisatti RH22/620ER Инструкция по эксплуатации онлайн [7/40] 101058

MAINTENANCE AND CARE

WARNING-Always unplug the machine before

carrying out work on it.

- When you notice a decrease in hammer output, take

the machine to an Ofcial Service Centre.

- Tool inspection: Using a blunt cutting tool leads to

less efcient work and could damage the motor, there-fore

cutting tools should be sharpened or replaced as soon as

any wear is noticed. Daily: Clean the tool-holder.

- Inspect the mounting screws: Regularly inspect all the

mounting screws and ensure they are rmly tight-ened.

Should any screw be loose, tighten it immedi-ately. Failure

to do so could put you at serious risk.

- Motor maintenance: Take the utmost care to ensure

that the motor winding is not damaged and does not

become damp with oil or water.

- Brush replacement: The brushes disconnect auto-

matically and should be replaced after 150-200 hours

use or when they are less than 10 mm long. Have them

replaced by an Ofcial Service Centre.

- Clean the machine thoroughly after each use with a

blast of dry air.

- The vents of the machine should be kept clear at all

times.

- Check that the mains lead is in good condition. If it is

not, take it to an Ofcial Service Centre to have it re-placed.

- Use only Felisatti accessories and spares. The parts

the changing of which is not covered in this instruction

manual, should be replaced in a Felisatti Ofcial Ser-vice

Centre (See Warranty/Ofcial Service Centre ad-dress

leaet).

WARRANTY

See general warranty conditions printed on the

attached sheet.

DISPOSAL

WARNING! Do not dispose of electric tools in the

household waste!

In accordance with European Directive 2002/96/EC

relating to old electrical and electronic appliances and

its translation into national law, used electric tools must

be collected separately and recycled in an ecologically

desirable way.