KRAUSE TELEVARIO 4x4 122162 Инструкция к товару онлайн [52/159] 841794

Ladder component(s): Inspection point: yes/no

1. General

inspection

points

All connecting elements (rivets, screws, bolts etc.) have to be in place.

Are any of the connecting elements loose or corroded? Is there any dirt

(e.g. soil, mud, paint, oil or grease) on the ladder?

7. Maintenance/Servicing: The maintenance and servicing work performed on the ladder is in-

tended to make sure that the ladder is working properly. The ladder must be regularly checked for

damage. Make sure all of the ladder‘s moving parts are in proper working order. All moving parts

must be regularly lubricated. Any repairs to the ladder must be performed by a qualiﬁed person and

in correspondence with the manufacturer‘s instructions. Always clean the ladder and the moving

parts in particular immediately after use if the ladder becomes dirty. Only use conventional, water-so

luble cleaning agents. Do not use aggressive or abrasive cleaning agents. If the ladder is being used

commercially, it must be regularly inspected by an authorised person to make sure that it is in proper

working order (visual inspection and performance test). In this case, it is essential to draw up an

inspection schedule that deﬁnes the type, scope and intervals at which the requisite inspections are

performed. The intervals between these inspections have to be determined in accordance with the

relevant operating conditions, in particular the relevant frequency of use, loads applied to the ladder

during use and the frequency and severity of any defects identiﬁed during previous inspections. The

owner is also responsible for removing defective ladders from use and storing them in such a way as

to prevent their use until they have been properly repaired or disposed of.

When not in use, this single or multiple hinge ladder must be stored either fully

extended and resting ﬂat against the ﬂoor, or folded together in an upright position

standing on the ﬂoor.

Important information on using the hinge ladder as a work platform: This ladder

must only be used with platforms recommended for such use by the manufacturer.

Always secure the platform before use in such a way that it cannot be accidentally

moved.

Never use this hinge ladder in this position.

Important information on using the hinge ladder as a work platform: Observe the

manufacturer‘s information on the platform‘s maximum load capacity.

Always make sure that all of the safety hinges have properly engaged / are safely

locked in place before using the ladder.

The inner ladder section of BG 1223 must only be used with an

additional stabiliser.

BG 1223 must not be used with both extensions on both sides being

extended at the same time.

BG 1220 + 1221 (4 x 3) Do not use the top ladder section as a platform.

Joints/hinges must be regularly lubricated

6.4. Using the single or multiple hinge ladder