Palram HYBRID 6-6 701616 Инструкция к Palram HYBRID 6-6 701616 онлайн [4/108] 849328

During Assembly

Make sure the base is square by measuring the diagonals and level by using a spirit level.

You may use silicone lubricant spray in order to help you slide the panels into the profiles.

Do not spray the polycarbonate panels.

Use a rubber mallet if necessary.

All panels with the stamped words "THIS SIDE OUT" must be facing out to create

full UV protection. Remove plastic sticker as panels are locked in place.

Steps 15, 16, 23, 24, 26, 34, 35, 38, 39, 40, 42, 47, 50:

Please Note! Each of the 3 greenhouses come with its compatible panels kit as shown in the

content list and in the relevant assembly steps.

When encountering the information icon, please refer to the relevant

assembly step for additional comments and assistance.

This icon indicates

that the installer should

be inside the product.

This icon indicates that

the installer should be

outside the product.

Attention

During assembly use a soft surface below the parts to avoid scratches and damages.

Steps

Step 5: Part 994, 995 are in the back of the greenhouse. Attaching them determines the front side of

the greenhouse.

Steps 8, 11:The oval hole in the crossbars 256 should always be assembled to the base of the

greenhouse.

Step 9 Door Assembly: Determines door direction. Part 987 is the side that the door hinges will be

located. The door can be installed either as a left or right hand door. These instructions show a right

hand door assembly.

Window Assembly

Step 31: Decide on the window's location before assembly. Window can be installed in one of the

indicated options.

Step 47: In case the window doesn't closed properly, please release the screws, adjust the profile

and tighten the screw.

* Please tighten all screws when completing assembly.

Screws 411 and nuts 412 & 466 are used thruoghout the assembly process.

Screws 411 are to be assembled from the outside and nuts 412 & 466 from the inside of

the greenhouse.

Do not fasten screws and nuts (411,412 & 466) more than 2-3 turns only. Do not tighten

them until completion of the panels'assembly, if not specified otherwise.

However, in some steps, temporary tightening of a few screws may be needed to

prevent a profile from falling.

Note: Firmly connect t e product to a eve surface immediately after completion of the

assembly.

Anchoring this product to the ground is essential to its stability and rigidity. It is required

to complete this stage in order for your warranty to be valid.