Home
Главная
Trotec
Гигрометры (влагомеры)
TC100 3510007010
Руководство по эксплуатации Страница: 8

Trotec TC100 3510007010 Руководство по эксплуатации онлайн [8/13] 850032

7 EN

Operating manual – thermohygrometer TC100

Transport and storage

Note

If you store or transport the device improperly, the

device may be damaged.

Note the information regarding transport and storage of

the device.

Transport

The manufacturer packed the device to the best of his abilities

to protect it against transport damages.

Storage

When the device is not being used, observe the following

storage conditions:

• dry and protected from frost and heat

• protected from dust and direct sunlight

• The storage temperature is the same as the range given in

the Technical data chapter.

• Remove the batteries from the device.

Operation

Inserting the batteries

Note

Make sure that the surface of the device is dry and the

device is switched off.

1. Open the battery compartment by sliding open the

cover(13) with your fingers.

2. Remove the battery compartment cover.

3. Insert the batteries (4batteries of typeAAA) into the

battery compartment with correct polarity.

4. Slide the cover back onto the battery compartment.

Switch-on and measurements

Note:

Note that moving from a cold area to a warm area can lead to

condensation forming on the device's circuit board. This

physical and unavoidable effect can falsify the measurement. In

this case, the display shows either no measured values or they

are incorrect. Wait a few minutes until the device has become

adjusted to the changed conditions before carrying out a

measurement.

1. Briefly press the Power button(3).

ð The display will be activated and depending on the

previously used settings either "Indoor" or "Outdoor"

will be displayed for the WBGT measuring mode.

ð An acoustic signal will be emitted, then the device is

ready for operation.

ð The GTindication(21) and the currently measured globe

temperature value(18) will be displayed.

2. Point the device at the area to be measured.

ð Wait for a moment to achieve a stable measured value.

Trotec TC100 3510007010 Руководство по эксплуатации онлайн [8/13] 850032

Похожие устройства