Timberk N28, 50л. T-WSS50-N28-V Инструкция по эксплуатации онлайн [28/44] 857580

Timberk N28, 50л. T-WSS50-N28-V Инструкция по эксплуатации онлайн [28/44] 857580
IM2022
28
Problem
Possible causes
Remedy
Indicator on the
control panel will
not come on,
water does not
heat
1. Temperature control
device is damaged.
1. Contact a repair specialist
at the authorized service
center.
2. Temperature limiter
has been activated or not
switched on.
see clause 9 Maintenance,
paragraph 5.
3. Temperature limiter is
damaged.
3. Contact a repair specialist
at the authorized service
center.
Water does not
flow out of the
hot water tap
1. Water supply is cut off.
1. Wait until water supply
resumes.
2. Water pressure is too
low.
2. Turn the water heater on
again when normal water
pressure is available.
3. Cold water inlet tap is
closed.
3. Open the cold water inlet
tap.
Water
temperature is
too high
1. Water temperature
control system
is damaged.
1. Contact a repair specialist
at the authorized service
center.
Water leakage
1. Seal is broken at the
point of pipe connection.
1. Replace the pressure seal.
Water leaks from
the product case
1. The internal tank is
broken (corrosion).
Contact a repair specialist at
the authorized service center.
2. Seal is broken at the
point of the connection of
the heating element.
Water from the
safety relief
valve port even
when the product
does not heat
water
Water main pressure
exceeds or close to 0.7
MPa.
Mount a pressure-reducing
valve before the water heater
and reduce pressure in the
water main.
11. ELECTRICAL CIRCUIT DIAGRAM
Fig. 8
12. UTILIZATION RULES
After the lifetime of the device expires, it should be recycled in
compliance with the laws, rules and methods in region of recycling.
Detailed information about the recycling of the device, you can receive

Содержание

Похожие устройства

Скачать