Home
Главная
Oleo-Mac
Бензиновые
MB90 5606-9001E1
Руководство пользователя Страница: 21

Oleo-Mac MB90 5606-9001E1 Руководство пользователя онлайн [21/39] 857781

15. TROUBLESHOOTING CHART

WARNING: Always stop unit and disconnect spark plug before performing all of the recommended

remedies below except remedies that require operation of the unit.

When you have checked all the possible causes listed and you are still experiencing the problem, see your Servicing

Dealer. If you are experiencing a problem that is not listed in this chart, see your Servicing Dealer for service.

PROBLEM POSSIBLE CAUSE SOLUTION

Engine will not start or will

run only a few seconds after

starting.

(Make sure Ignition switch

is in start position “I”)

1. No spark

2. Flooded engine.

1. Watch for spark at spark plug tip. If

there is no spark, repeat test with a

new spark plug (RCJ6Y).

2. Follow procedure page 26 If engine

still fails to start, repeat procedure

with a new spark plug.

Engine starts but will not

accelerate properly or will not

run properly at high speed.

Carburetor requires

adjustment.

Contact a Servicing Dealer for

carburetor adjustment.

Engine does not reach full

speed and / or emits

excessive smoke

1. Check oil fuel mixture.

2. Air lter dirty.

3. Carburetor requires

adjustment.

1. Use fresh fuel and the correct

2-cycle oil mix.

2. Clean per instruction in

Maintenance-Air Filter Section.

3. Contact a Servicing Dealer for

carburetor adjustment.

Engine starts, runs and

accelerates but will not idle.

Carburetor requires

adjustment.

Contact a Servicing Dealer for

carburetor adjustment.

The engine starts and runs,

but the air ow is low

1. Safety guard blocked

2. Impeller damaged

1. Clean safety guard

2. Contact an Authorised Service

Centre

The engine starts and runs,

but the liquid ow rate is

poor

Liquid lter or pipes blocked Clean or replace

Oleo-Mac MB90 5606-9001E1 Руководство пользователя онлайн [21/39] 857781

Содержание

Похожие устройства