Hilti SR 30-A36 чемодан 2162156 Инструкция к товару онлайн [26/224] 861169

20 English 2186517

*2186517*

5 Preparations at the workplace

CAUTION

Risk of injury by inadvertent starting!

▶ Before inserting the battery, make sure that the product is switched off.

▶ Remove the battery before making any adjustments to the power tool or before changing accessories.

Observe the safety instructions and warnings in this documentation and on the product.

5.1 Charging the battery

1. Before charging the battery, read the operating instructions for the charger.

2. Make sure that the contacts on the battery and the contacts on the charger are clean and dry.

3. Use an approved charger to charge the battery.

5.2 Inserting the battery

CAUTION

Risk of injury by short circuit or falling battery!

▶ Before inserting the battery, make sure that the contacts on the battery and the contacts on the product

are free of foreign matter.

▶ Make sure that the battery always engages correctly.

1. Charge the battery fully before using it for the first time.

2. Push the battery into the battery holder until it engages with an audible click.

3. Check that the battery is seated securely.

5.3 Removing the battery

1. Press the release buttons on the battery.

2. Pull the battery out of its holder in the device.

5.4 Installing the scaffold hook (accessory) 2

1. Engage the transport lock.

2. Install the scaffold hook.

5.5 Inserting the saw blade 3

Use only saw blades with a 1/2" connection end.

1. Activate the transport lock or separate the battery from the power tool.

2. Check that the connection end of the accessory tool is clean and lightly greased. Clean it and grease it if

necessary.

3. Push the locking lever up as far as it will go and hold it in this position.

4. Push the saw blade into the chuck from in front.

5. Allow the locking lever to return to its original position.

6. Grip and pull the saw blade to check that it is locked in position.

5.6 Installing the dust removal adapter (USA: accessory) 4

1. Pull the contact shoe out.

2. Set the dust removal adapter on the contact shoe mount.

3. Insert the lightly greased contact shoe fully into the guide.

Printed: 19.09.2019 | Doc-Nr: PUB / 5391388 / 000 / 03