Hilti SCW 22-A чемодан 2043328 Инструкция к товару онлайн [34/456] 861545
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Hilti SCW 22-A чемодан 2043328 Инструкция к товару онлайн [34/456] 861545

Hilti SCW 22-A чемодан 2043328 Инструкция к товару онлайн [34/456] 861545
28 English 434723
*434723*
▶ Never store batteries in direct sunlight, on heating units or behind a window pane.
▶ Store the tool and batteries in a place where they cannot be accessed by children or unauthorized
persons.
▶ Check the tool and batteries for damage before use after long periods of storage.
8 Troubleshooting
▶ If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
8.1 The circular saw is not in working order.
Malfunction Possible cause Action to be taken
The LEDs indicate nothing. The battery is not fully inserted. ▶ Insert the battery.
The battery is discharged. ▶ Charge the battery.
The battery is too hot or too cold. ▶ Bring the battery to the correct
ambient temperature.
1 LED blinks. The battery is discharged. ▶ Charge the battery.
The battery is too hot or too cold. ▶ Bring the battery to the correct
ambient temperature.
4 LEDs blink. The circular saw was overloaded
briefly.
▶ Release the control switch and
then press it again.
The overheating prevention cut-out
has been activated.
▶ Allow the circular saw to cool
down to cool down and clean
the air vents.
8.2 The circular saw is in working order.
Trouble or fault Possible cause Action to be taken
The on/off button cannot be
pressed, i.e. the button is
locked.
Not a fault (safety function). ▶ Press the safety lock.
Running speed suddenly
drops considerably.
The battery is discharged. ▶ Charge the battery.
Saw advance pressure is too high. ▶ Reduce advance pressure and
switch the product back on.
The battery runs down more
quickly than usual.
Battery condition is not optimal. ▶ Replace the battery.
The product doesn’t restart
by itself after the saw blade
has stalled.
The overload cut-out has been
activated.
▶ Press the switch-on interlock
and the on/off button again.
The battery does not en-
gage with an audible "double
click".
The retaining lugs on the battery
are dirty.
▶ Clean the retaining lugs and refit
the battery.
The circular saw or battery
gets very hot.
Electrical fault. ▶ Switch off the circular saw
immediately. Remove the
battery and keep it under
observation. Allow the battery
to cool down. Contact Hilti
service.
The product is overloaded (appli-
cation limits exceeded).
▶ Select a tool that is suitable for
its intended use.
No suction power or reduced
suction power
The chip ejector channel is
blocked.
▶ Clean the chip / dust channel.
→ page 26
Printed: 24.05.2019 | Doc-Nr: PUB / 5070513 / 000 / 04

Похожие устройства

Скачать