Philips AWH1053/51(55LA) Руководство по эксплуатации онлайн [11/28] 864940

8.3 Method of use

CAUTION:

● Connected to power

When the power is turned on, the display screen will light up for 3 seconds, and the buzzer will beep once to

he

consumption power for 1 second then enters standby mode.

● Turn on the device

When there is no water at the water inlet, press " " button to turn on the device. You can operate any function

key to set it, but the water heater does not work. In the 

rk.

● Operation

During the wo

beep once every time you press it as a reminder (the temperature setting range is 30-55℃ ).

● Shutdown

Press the " 

Notes before connected to the power:

● Check whether the leakage protection switch is installed in a suitable position and whether it can operate.

●

● Check whether there is any water leakage at each interface, and then turn on the appliance only when

wa

● Whe

body under the water to avoid being scalded by hot water.

● Users are requested to maintain good habits: it is recommended to turn on the water before turning on

the

Introduction about the display

● Display the set temperature and outlet water temperature under normal conditions.

Fault code display: When a failure occurs, fault codes (F5, E4, E1, etc.) are displayed.

Figure F

EN 8