Philips AWH1053/51(55LA) Руководство по эксплуатации онлайн [9/28] 864940

8.2 INSTALLATION STEPS

NOTICE:

The water heater must be installed by the company's authorized personnel.The supplied accessories must be used

during installation; unauthorized replacement is not allowed. If the above rules are not complied with, the

company will not be liable for any direct or indirect losses caused thereby.

Step 1:Installation preparation

● 

instruments.

● Check whether the electric water heater is in good condition, and whether the accompanying documents and

accessories are complete.

● Read this manual carefully to understand the functions, operation methods, installation requirements and installation

methods of the electric water heater.

● Check the user's power supply, it must be 220V- 50Hz power supply;The location of the leakage protection switch

should be placed in a safe place where there will be no danger of electric shock and where water cannot be splashed.

Check the leakage protection switch used in the electric water heater by visual inspection and using specialized

measuring devices (phase meter, test pen, grounding resistance meter, etc.) to ensure that the live wire and neutral

wire are installed correctly and grounded reliably; Check whether the electric meter capacity, leakage protection

switch, electric wire can meet the power requirements of the water heater, see the "technical performance

parameters"; Check the tap water pressure with a pressure gauge, if the tap water pressure is greater than 0.7 MPa, a

pressure reducing valve should be installed on the inlet pipe.

● 





direct sunlight, rain and wind;Try to avoid places prone to vibration;Try to shorten the distance between the electric



reduce the heat loss of the pipeline;The bearing capacity of the installation surface should not be less than 4 times the



under the electric water heater to ensure safety.

● For thosedo not meet the installation requirements of electric water heaters, professional installation personnel



be refused.

Step 2. Installation operation

● The installation of the electric water heater should use the attached accessories, and professional installation

personnel should not replace, omit or modify at will.

● During installation, attention should be paid not to damage the safety structure of the building.

● 

● The water heater must be installed vertically.

● 







CAUTION:

The ground wire must be reliably grounded, otherwise it may cause safety accidents.

The leakage protection switch must be installed in a dry place where cannot be sprayed by water.

EN 6