Piusi K900 METER 3in BSP F0049900B Инструкция онлайн [41/60] 865689

41/124

41 /6 0

This manual is the property of PIUSI S.p.A. Any reproduction, even partial, is forbidden.

Translated from Italian

G DAILY USE

FOREWORD

The only operations that need to be done for daily use are partial and/or resettable

total register resetting. The user should use only the dispensing system of K900. Oc-

casionally the meter may need to be configured or calibrated. To do so, please refer to

the relevant chapters.

Below are the two typical normal operation displays. One display page shows the partial and reset total

registers. The other shows the partial and general total. Switchover from resettable total to general total

display is automatic and tied to phases and times that are in factory set and cannot be changed.

The Partial register positioned in the top part of the display indicates the

quantity dispensed since the RESET key was last pressed

The RESET Total register, positioned in the lower part of the display, indicates

the quantity dispensed since the last RESET Total resetting. The RESET Total

cannot be reset until the Partial has been reset, while vice versa, the Partial can

always be reset without resetting the RESET Total. The unit of measurement of

the two Totals can be the same as the Partial or else different according to the

factory or user settings.

The General TOTAL register (Total) can never be reset by the user. It continues

to rise for the entire operating life of the meter.

The register of the two totals (Reset Total and Total) share the same area and

digits of the display. For this reason, the two totals will never be visible at the

same time, but will always be displayed alternately.

The General Total (Total ) is shown during Meter standby

The Reset Total is shown:

- At the end of a Partial reset for a certain time (a few seconds)

- During the entire dispensing stage

- For a few seconds after the end of dispensing. Once this short time has

expired. Meter switches to standby and lower register display switches to

General Total

NOTE

6 digits are available for Totals, plus two icons x 10 / x100. The increment

sequence is the following:

0.0 -> 99999.9 -> 999999 -> 100000 x 10 -> 999999 x 10 ->100000 x 100 ->

999999 x 100