Yato YT-36742 Инструкция по эксплуатации онлайн [7/36] 869766

ORIGINAL INSTRUCTIONS

bystanders. Try to stop or at least limit the release to the environment as far as possible. Use appropriate respiratory protection. Spray

water mist to minimise and limit gas spread.

APPLIANCE OPERATION

Gas container installation (II)

Install the container outdoors or in a well-ventilated area away from sources of ﬁ re or excessive heat. Maintain distance from bystanders.

The product is intended for self-sealing containers only, which means that the gas container can be removed from the burner at any time,

without the need to empty it completely. The presence of gas in the container can be checked by shaking it. If the overﬂ owing liquid is

heard, it means that there is gas in the container.

Attention! This torch is adjusted only to the vessels complying with the standard EN 417 equipped with non-threaded quick coupling with

the recession inf ﬁ xing collar. It is forbidden to connect the gas containers with another kind of ﬁ xture and to connect the gas containers

which are not in conformity with the standard EN 417.

The installation of gas container should be done outdoors or in a well ventilated room. It should be performed way from sources of ﬁ re or

excessive heat. You should also keep the distance from bystanders.

Close the gas valve, to do this you should turn the regulator knob all the way in the direction marked with the symbol “-” or OFF.

Make sure that the gasket of torch connection is not damaged or worn out. Installation of the gas container is prohibited in the case of

observation of any traces of wear or damage. Rotate the gas connection so that the plastic plates of ring were placed between the metal

parts of connector. Connect container to the torch so that the protrusion of gas connector ﬁ ts the recession in container collar (II). Then

push the gas container to torch and turn it clockwise.

Attention! It is forbidden to use the torch without a properly installed gas container, for example, with the container, which is not accurately

attached.

Make sure that there are no gas leaks. Use the soap water for that, if gas bubbles are formed, this means a leak. It is prohibited to work

with the unit in which the gas leak was detected. It is forbidden to check the tightness of the connection by using a ﬂ ame.

Burner operation

Make sure that there are no gas leaks, then open the valve approximately halfway by turning the knob in the direction of the plus symbol

(III). The sound of the gas escaping from the nozzle outlet should be audible. Direct the burner so that the nozzle outlet is at least 3 metres

from any object and press the magneto button. This will ignite the gas at the burner outlet with a built-in ignition device. Adjust the ﬂ ame

height with the regulator knob. Wait about a minute before starting work, observing for any side eﬀ ects at all times. Gas ﬂ ickering may occur

during the initial warm-up phase. During this time, the gas container should be in a vertical position. If the ﬂ ickering phenomenon does not

resolve spontaneously, extinguish the ﬂ ame and contact the manufacturer.

Caution! Do not put away the ignited burner. Do not heat the gas container.

Burner extinguishing

Turn the regulator knob as far as possible in the direction of the minus symbol, this will extinguish the ﬂ ame.

Leave the burner to cool down.

Caution! Cooling the appliance with a water jet is forbidden.

Disconnect the gas container from the burner.

Appliance maintenance

Clean the appliance with a soft, damp cloth. Remove heavier soiling with suds dissolved in water. Do not use abrasive cleaning agents. In

case of any faults and contamination of the nozzle, contact the manufacturer’s service centre. It is forbidden to clean the nozzle on your

own, especially with sharp objects. Do not modify the appliance. Do not use the appliance with damaged parts.

Storage

Store the product in delivered unit packaging or similar closed containers. Store the product in a dark, dry, and well-ventilated place not

accessible to unauthorised persons, especially children. Store the appliance in a vertical position. Do not expose to temperature above

C and avoid prolonged exposure to the sun.