Home
Главная
Vitek
Пылесосы вертикальные
VT-8132
Руководство по эксплуатации Страница: 4

Vitek VT-8132 Руководство по эксплуатации онлайн [4/24] 876559

ENGLISH

• Close supervision is necessary when chil-

dren or people with disabilities are near the

operating unit.

• This unit is not intended for usage by chil-

dren.

• During the unit operation and breaks

between operation cycles place the unit

out of reach of children.

• The unit is not intended for usage by physi-

cally or mentally disabled persons (including

children) or by persons lacking experience

or knowledge if they are not under supervi-

sion of a person who is responsible for their

safety or if they are not instructed by this

person on the usage of the unit.

• Do not leave children unattended to pre-

vent using the unit as a toy.

• For children safety reasons do not leave

polyethylene bags used as packaging

unattended.

Attention! Do not allow children to play with

polyethylene bags or packaging film. Danger

of suffocation!

• Regularly check the power plug and power

cord integrity for damages.

• Never use the unit if the power cord or the

power plug is damaged, if the unit works

improperly, after it was dropped or in case

of leakage.

• Do not attempt to repair the unit. Do not

disassemble the unit by yourself, if any

malfunction is detected or after it was

dropped, unplug the unit and apply to any

authorized service center from the contact

address list given in the warranty certificate

and on the website www.vitek.ru.

• Transport the unit in the original packag-

ing only.

• Keep the unit out of reach of children and

people with disabilities.

THE UNIT IS INTENDED FOR HOUSEHOLD

USE ONLY, ITS COMMERCIAL USAGE AND

USAGE IN PRODUCTION AREAS AND WORK

SPACES IS PROHIBITED.

SAFETY PRECAUTIONS

• Do not use the vacuum cleaner near hot

surfaces, ashtrays and in places where

inflammable liquids are stored.

• Take sharp objects away from the floor

before cleaning to prevent unit damage.

ASSEMBLING THE VACUUM CLEANER

After unit transportation or storage at

low temperature keep it for at least three

hours at room temperature before switch-

ing on.

– Unpack the unit completely and remove

any advertising stickers that can prevent

the unit operation.

– Check the unit for damages; do not use a

damaged unit.

– Before switching the unit on, make sure

that your home mains voltage corresponds

to the unit operating voltage.

Installing and removing the brush (1)

– Install the brush (1) in the setting place (9).

To remove the brush (1) pull it downward.

Installing and removing the dust bin (2)

– Before installing or removing the dust

bin (2) make sure that the vacuum cleaner

is switched off and the power plug is not

inserted into the socket.

– To remove the dust bin (2) press on the

lock (3) and remove the dust bin (2).

– To install the dust bin (2) to its place match

the ledge on the body with the groove on

the dust bin (2), lift the dust bin (2) until the

lock (3) clicking.

– Before installing the dust bin (2) back

to its place make sure that the inlet filter

(11) and the HEPA filter (10) are installed

properly.

ATTENTION! Do not use the vacuum cleaner,

if the inlet filter (11) and the HEPA filter (10)

are not installed in the dust bin (2).

Installing and removing the handle (6)

– Move the slide (8) and insert the exten-

sion pipe (6) into the handle (5), lift the

slide (8).

– To remove the handle (6) move the slide (8)

and pull the handle (6) upwards.

– When using the vacuum cleaner without

the extension pipe (6) hold it by the han-

dle (5).

IM VT-8132.indd 4 21.08.2018 11:20:12

Vitek VT-8132 Руководство по эксплуатации онлайн [4/24] 876559

Похожие устройства