Home
Главная
Kenwood
Насадки для кухонного комбайна
для пасты KAX92.A0ME
Руководство по эксплуатации Страница: 4

Kenwood для пасты KAX92.A0ME Руководство по эксплуатации онлайн [4/202] 884754

Kenwood для пасты KAX92.A0ME Руководство по эксплуатации онлайн [4/202] 884754

4

C

Fit the securing nut and

hand tighten. (Do not use

the spanner/pusher as this is

to assist with removal only).

O

Make sure the securing nut

is almost flush against the

body of the attachment.

D

Lift off the slow speed outlet

cover.

E

With the attachment in

position shown, locate to the

slow speed outlet and rotate

to lock in place.

F

Fit the hopper.

Cutting Assembly

Optional: The cutting assembly

7

and

8

can be fitted to the

assembled pasta shaper to assist

with cutting the pasta into the

desired lengths.

G

With the handle of the

cutting blade uppermost,

unscrew the clamp ring

slightly. Place over the

securing nut and twist if

necessary until fully home

on the attachment. The die

should fit flush with the front

of the cutting assembly.

Hold the edge of the cutting

assembly and at the same

time tighten the clamp ring

by turning away from you.

Note: Whenever you fit

or remove the cutting

assembly, always hold the

edge of the assembly in one

hand and twist the clamp

ring with the other.

To Use Your Pasta

shaper

Refer to illustrations

H

–

I

O

Use speeds 2-3 to process

your pasta.

O

Make your pasta mix

following a recipe supplied.

O

Do not make the mix too

dry as it could break your

pasta shaper or machine.

It should resemble coarse

breadcrumbs or a coarse

crumble texture. The

particles should be separate

but if squeezed together it

should form a clump which

bonds together.

H

Switch the machine onto

speed 2-3.

Place some of the mix onto

the hopper. Feed a small

amount of mix into the

feed tube at a time. Allow

the scroll to clear before

continuing. If the feed tube

becomes clogged use the

end of the spanner/pusher

handle to push the mix

onto the scroll (do not use

anything other than the

spanner handle and do not

push too hard). Never let the

feed tube fill up.

I

When the pasta is long

enough, move the handle on

the cutting assembly back

and forth to cut the pasta

into the desired length.

Alternatively if the cutting

assembly is not fitted use a

knife to cut the pasta.

O

To change dies remove the

cutting assembly by holding

the edge in one hand and

twist the clamp ring towards

you. Remove the securing

nut (use the spanner/pusher

to loosen the securing nut if

necessary) and switch briefly

to speed 1 to eject the die.

Remove the die and any

visible excess pasta and then

fit the desired die. Replace

the securing nut and cutting

assembly.

Warning

The pasta shaper will get

hot in use – this is normal

and is caused by the pasta

being compressed in the

attachment.

Похожие устройства