Home
Главная
Brayer
Роботы для мойки окон
BR5000 синий
Руководство по эксплуатации Страница: 14

Brayer BR5000 синий Руководство по эксплуатации онлайн [14/68] 884950

• In this case, it is recommended to switch on the auto

clean the right and then down mode by pressing the

button (19) « » on the remote control (17) or the

auto clean left and then down mode by pressing the

button (27) « » on the remote control (17).

The robot did not nish cleaning the window and

stopped in the middle of the window

• To resume cleaning, press the button (19) «

» or

(27) « » on the remote control (17).

The robot does not move smoothly or moves jerkily.

• The cleaning cloths (11) are very dirty, replace the

cloths (11) and continue operation.

• Check the fastening of the driving disks (15), the

disk (15) fastening screw may have become loose.

Tighten the fastening screw by turning it clockwise.

There are round spots left on the window after

cleaning.

• The cleaning cloths (11) are very dirty. Replace the

cloths (11) with clean ones and repeat cleaning

where the stains remain.

The robot stops at a height out of range, the power

is turned o󰀨, the red indicators (4, 13) and blue

indicators (3, 12) ash alternately and you hear a

sound signal

• Slowly pull the device towards you by the safety rope

(6). Pull the safety rope (6) at an angle parallel to the

glass to prevent the robot from falling.

• Hold the handle (1), press and hold the on/o󰀨 button

(2) for 2 seconds, the vacuum pump will switch o󰀨,

remove the robot from the glass.

• Check the mains socket, the contact in the sockets

(8, 32), check the power cord (30) or the extension

cord (32) for breaks.

The robot stops when encountering unknown

obstacles, the red indicator (4, 13) ashes, there is

no sound signal

• Return the robot to a safe location with the remote

control (17) by pressing the corresponding direction

button.

• Slowly pull the device towards you by the safety rope

(6). Pull the safety rope (6) at an angle parallel to the

glass to prevent the robot from falling.

• Remove the obstacles on the window.

• Check the correct installation of the cleaning rings

(16) for possible air leaks.

The robot cleaned the window but did not stop

automatically

• Stop the robot by pressing the start/pause button (21)

» on the remote control (17).

The robot doesn’t spray water

• Check the water in the water tank and add more, if

necessary.

• Check the water spraying nozzles (10) and clean

them, if necessary.

Brayer BR5000 синий Руководство по эксплуатации онлайн [14/68] 884950

Похожие устройства